User manual SONY ST-SE200

[. . . ] The following icon is used in this manual: Indicates hints and tips for making the task easier. Place the unit in a location with adequate ventilation to prevent heat buildup and prolong the life of its components. â· Do not place the unit near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. [. . . ] set the aerial to the orientation which provides the best receiving condition. If a high pitched noise (beat noise) occurs when recording AM broadcasts, adjust the position of the AM loop aerial so that the noise disappears. If you live in a building constructed of reinforced concrete, or with a steel frame, you may not be able to achieve good reception since the radio waves become weaker indoors. Try repositioning the loop aerial while tuning. Placing the supplied AM loop aerial near a window will help improve reception quality. With an FM outdoor aerial, you can obtain a higher FM broadcast sound quality. We recommend that you use the supplied FM wire aerial only temporarily until you install an FM outdoor aerial. Be sure to turn off the power to both components before connection. Connect the white plugs to the white (L) jacks and the red plugs to the red (R) jacks. Insert the plugs completely into the jacks; incomplete connections may cause noise. Connect the supplied FM wire aerial or an FM outdoor aerial (not supplied) to the FM terminals on the back of this unit. If not, set the selector to the correct position using a screwdriver before connecting the mains lead. Connect the mains lead to an AC OUTLET on the rear panel of TA-AV561 or TA-AV661 after completing all of the previous connections. If you connect an outdoor aerial, be sure to connect a ground wire (not supplied) to the AM ANTENNA y terminal (in addition to the AM loop aerial) for lightning protection. Connect the mains lead to a wall outlet after completing all of the previous connections. This section describes various ways to tune in AM and FM broadcasts. [. . . ] / Preset the stations again if you've moved. After turning the power back on, press MEMORY SCAN and >10 simultaneously. This empties any frequencies stored in the preset memory. [. . . ]