User manual SONY STR-K700 SPEAKER CONNECTIONS

[. . . ] The model number and the serial number are located at the rear. record these numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this product. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. This device complies with Part 15 of the FCC Rules. Operations is subject to the following two conditions : (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Unplug the AC power adaptor from the AC outlet when it will not be used for a long period of time. To disconnect the AC power adaptor, pull it out by the plug. Be sure that nothing metallic comes into contact with the metal parts of the AC power adaptor. If it does a short may occur and the unit may be damaged. Do not place the unit in a location where it is: ­ Extremely hot or cold ­ Dusty or dirty ­ Very humid ­ Vibrating · Clean the cabinet with a soft cloth slightly moistened with water or mild detergent solution. ⷠDo not use alcohol, benzene, or thinner to clean the cabinet, as they may mar the finish. If you run into any problem using the unit, first check the power supply source. Then use the following table for troubleshooting. Should the difficulty persist disconnect the power source and contact your Sony dealer or local authorized Sony service facility. If your TV has a 21-pin connector (EUROCONNECTOR), use the 21-pin connector supplied with the camcorder. [. . . ] Should the difficulty persist disconnect the power source and contact your Sony dealer or local authorized Sony service facility. If your TV has a 21-pin connector (EUROCONNECTOR), use the 21-pin connector supplied with the camcorder. No picture and no sound at all ⷠThe AC power adaptor is not connected to an AC outlet. The power of the receiver is turned off (OFF). [. . . ]