User manual SONY STR-LSA1

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Should any solid object or liquid fall into the cabinet, unplug the receiver and have it checked by qualified personnel before operating it any further. Slide out and remove the battery case, and insert a new lithium battery CR2025 with the + side facing up. And then, slide the battery case back in. [. . . ] Z You can change to the tuner quickly RDS may not work properly if the station you tuned to is not transmitting the RDS signal properly or if the signal strength is weak. After you disconnect the AC power cord of the receiver, RDS program station names may not be saved correctly. Z If you try to tune more precisely than is possible for the tuning scale You won't be able to tune in the exact frequency. For details on the buttons and controls used in this section, see "Brief descriptions of buttons and controls on the receiver used to receive broadcasts" on page 17 and "Brief descriptions of buttons on the remote used to receive broadcasts" on page 18. For details on the buttons and controls used in this section, see "Brief descriptions of buttons and controls on the receiver used to receive broadcasts" on page 17 and "Brief descriptions of buttons on the remote used to receive broadcasts" on page 18. Before tuning to preset stations, be sure to preset them by performing steps on "Presetting radio stations" below. Press TUNE MODE repeatedly until "AUTO" lights up in the display. When you rotate the dial clockwise, the receiver scans from low to high; when you rotate it counterclockwise, the receiver scans from high to low. When the receiver reaches either end of the band Scanning is repeated in the same direction. The receiver stops scanning whenever a station is received. Tune in the station that you want to preset using Manual Tuning or Automatic Tuning (page 18 and this page). "MEMORY" lights up in the display for several seconds. Do steps 6 and 7 before "MEMORY" turns off. rotate the jog dial to select the memory page and preset number. The memory page appears and the preset number flashes. The memory page and preset number indication changes each time you rotate the jog dial as follows: Z You can select the tuner quickly To select the memory page quickly Press SHIFT on the remote repeatedly. If "MEMORY" turns off or preset number stops flashing before you select the memory page and preset number, start again from step 4. Repeat steps 3 to 7 to preset another station. To change a preset number to another station Do steps 1 to 7 to preset the new station to the number. Press TUNE MODE repeatedly until "PRESET" lights up in the display. rotate the jog dial to select the preset station you want (or press PRESET +/­ on the remote repeatedly). Each time you rotate the jog dial (or press PRESET +/­ on the remote repeatedly), the receiver tunes in one preset station at a time, in the corresponding order and direction as follows: To select the memory page quickly Press SHIFT on the remote repeatedly. [. . . ] , Make sure that you've selected the correct component on the receiver. , The protective device on the receiver has been activated because of a short circuit. Turn off the receiver, eliminate the short-circuit problem and turn kn the power again. The left and right sounds are unbalanced or reversed. [. . . ]