User manual SONY ST-RDA2100ES B IM

[. . . ] 2-580-805-13(1) FM Stereo FM/AM Receiver Operating Instructions Owner's Record The model and serial numbers are located on the rear of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. STR-DA2100ES ©2005 Sony Corporation WARNING WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To prevent fire, do not cover the ventilation of the apparatus with newspapers, table-cloths, curtains, etc. [. . . ] XXX (Menu expanding) · ON The advanced parameters for the SP SET UP and LEVEL menus are displayed and can be adjusted. For details on each setup item, see pages 18, 37 and the following pages. · OFF The advanced parameters are not displayed x A/V SYNC XXX (Time alignment) Initial setting: 0 (0 ms) Let you delay the output of audio to adjust the gap between video and audio. You can adjust from 0 (0 ms) to 200 (200 ms) in 10 ms steps. x DEC. XXXX (Digital audio input decoding priority) Lets you specify the input mode for the digital signal input to the DIGITAL IN jacks. AUTO" for VIDEO 3 and TV/SAT, and "DEC. PCM" for DVD, MD/TAPE and SA-CD/CD. · AUTO Automatically switches the input mode between DTS, Dolby Digital, or PCM. · PCM PCM signals are given priority (to prevent the interruption when playback starts). Even when other signals are input, the sound is output. However, this receiver cannot decode DTS-CD when set to "DEC. PCM". Note x 96/24 DEC XXXX (DTS 96/24 decoding mode) DTS 96/24 · AUTO When a DTS 96/24 signal is input, it is played back at 96 kHz sampling frequencies. · OFF Even when a DTS 96/24 signal is input, it is played back at 48 kHz sampling frequencies. Notes · This parameter is valid only when A. F. D. In other sound fields, this parameter is always set to "OFF". · DTS 96/24 decoding is valid only when A. F. D. When the system is set to other sound fields, standard 48 kHz decoding is used. · Even when a DTS 96/24 signal is input, standard 48 kHz decoding is used if any speakers are set to "SMALL" or if the sub woofer is set to "NO". When set to "DEC. AUTO" and the sound from the digital audio jacks (for SA-CD/CD, etc. ) is interrupted when playback starts, set to "DEC. PCM". continued 39US x DUAL MONO XXXX (Digital broadcast language selection) Lets you select the language you want to listen to during digital broadcast. This feature only functions for Dolby Digital sources. · M/S (Main/Sub) Sound of the main language will be output through the front left speaker and sound of the sub language will be output through the front right speaker simultaneously. · MAIN Sound of the main language will be output. [. . . ] To switch the command mode of the receiver, press ?/1 to turn off the power. Then, press ?/1 while pressing INPUT MODE. Each time you press ?/1, the command mode switches between "C. MODE. AV2" and "C. MODE. AV1". (The initial setting is "C. MODE. AV2". ) To switch the command mode of the remote, see "Selecting the command mode of the remote" on page 54. [. . . ]