User manual SONY ST-RDA555ES

[. . . ] Should you notice an abnormality in the apparatus, disconnect the main plug from the AC outlet immediately. , 8 , cone type (2) Input: Built-in audio cable with stereo-mini plug (1): minimum input level 245mV, impedance 47 k Power outputs: 1 W + 1 W (at 8 , 10% harmonic distortion) Power requirements: 230 V AC, 50 Hz For power backup: 3 V DC, one CR2032 battery Dimensions: Approx. CR2032 battery Design and specifications are subject to change without notice. Hold down CLOCK/DATE until a short beep sounds. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Should the problem persists after you have made the following checks, consult your nearest Sony dealer. Remove the old battery and install a new one. the CD , radio or buzzer alarm does not sound at the preset alarm time. Hasn't "ALARM A" or "ALARM B" in the display gone out?The disc should be inserted with the label side up. dusty or defective disc -- Clean the disc with an optional cleaning cloth. Two short beeps sound and the setting is entered. When "ALARM A" or "ALARM B" does not appear with "BUZZER" in the display, press ALARM A or B again. Listening to the Sound from a Connected Optional Component 1 Connect the built-in audio cable with the stereo-miniplug on the bottom of the unit to the line output jack or headphones jack on the optional component (e. The bottom of the unit If "ALARM A" or "ALARM B" does not appear in the display, the alarm setting is not activated. You can only check the alarm setting when it is activated. Example: The following display shows the crrent time and the CD ALARM A for 7:00 am. You can play tracks repeatedly or in random order. Each press changes the play mode as follows: Display Indication None Play Mode (normal play) If you set the CD alarm and there is no disc in the CD player, the buzzer alarm will sound instead at the time set. In case of the alarm, the beeping of the alarm becomes louder after every few seconds in three progressive stages. An 8 cm CD can be played without an adaptor. Push PUSH OPEN/CLOSE to close the CD compartment lid. [. . . ] Two short beeps sound when the minimum frequency of each band is received during tuning. Hold down ALARM A or B until a short beep sounds. When you release TUNETIME SET + or ­ after locating your desired station, the display returns to the current time after about 10 seconds. * AMS = Automatic Music Sensor ** These operations are possible during both play and pause. [. . . ]