User manual SONY STRDH830

[. . . ] If you are not sure of the type of electrical power supplied to your home, consult your dealer or local power company. For those sets designed to operate from battery power, or other sources, refer to the operating instructions. This set may be equipped with a polarized ac power cord plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. [. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ⭠Consult the dealer or an experienced radio/TV technician for help. The supplied interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a fuse of the same rating as the supplied one and approved by ASTA or BSI to BS1362, (i. Avoid other metallic objects to contact with the connecting parts of the Cyber-shot Station and the power cord. Recording contents cannot be compensated for if playback is not possible due to damaged "Memory Stick Duo", a malfunction of your camera or the Cyber-shot Station, etc. Do not attempt to connect the supplied USB cable to the multi connector on the bottom of the camera. The STRDH830 can be used with the DSC-T100, DSC-T25, DSC-T20, DSC-W200, DSC-W90, DSC-W85, and DSC-W80 digital still cameras. Not all digital still cameras are available in all countries. When you place a digital still camera (here in after referred to as the "camera") on the Cyber-shot Station, you can use the Cyber-shot Station in the following way. The Cyber-shot Station can charge the battery pack inside the camera faster than the battery charger supplied with the camera. You can connect the Cyber-shot Station to your computer by using the supplied USB cable and transfer image data. In addition, system and product names used in this manual are, in general, trademarks or registered trademarks of their respective developers or manufacturers. However, the or marks are not used in all cases in this manual. See the table below and set the MODEL SELECT switch to match with your camera. [. . . ] The battery life varies according to how it is stored and the operating conditions and environment in which each battery pack is used. When you use data in the internal memory, do not insert the "Memory Stick Duo" into the camera. Be sure to turn off the camera before placing it on or removing it from the Cyber-shot Station. Tips You can attach the camera to the Cyber-shot Station smoothly by aligning the camera to the right corner of the Cyber-shot Station. [. . . ]