User manual SONY ST-RGX67ES

[. . . ] Before operating the receiver, check that the operating voltage is identical with your local power supply. The receiver is not disconnected from the AC power source (MAINS) as long as it is connected to the wall outlet, even if the receiver itself has been turned off. ⷠIf you are not going to use the receiver for a long time, be sure to disconnect the receiver from the wall outlet. To disconnect the AC power cord, grasp the plug itself; never pull the cord. [. . . ] The TV also turns on when you press VIDEO and switches to the appropriate video input. When you watch TV without using the receiver (only for Sony TVs) press TV CONTROL to set the remote to operate only the TV. When you press this button, the TV turns on and switches to the TV input. Sony VCRs are operated with a VTR 1, 2 or 3 setting. Now you can use the TAPE/MD button to control a second CD player. to reset the setting to the factory setting Repeat the above procedure. You will not have the stereo effect but the distortion will be reduced. To return to stereo mode, press this button again. This receiver lets you enter a station's frequency directly by using the numeric buttons (direct tuning). If you don't know the frequency of the station you want, see "Receiving broadcasts by scanning stations (automatic tuning)" on the next section. Before you begin, make sure you have: · If you cannot tune in a station and the entered numbers are flashing Make sure you've entered the right frequency. Do steps 4 and 5 before "MEMORY" goes out. press SHIFT to select a character (A , B or C). Each time you press SHIFT, the letter "A, " "B" or "C" appears in the display. While MEMORY is displayed, press the number you want to use (0 to 9). Repeat steps 2 to 5 to preset other stations. This receiver makes it easy to record to and from the components connected to the receiver. You don't have to connect playback and recording components directly: once you select a program source on the receiver, you can record and edit as you normally would using the controls on each component. Before you begin, make sure you've connected all components properly. You can record TV program or digital broadcasting system using the receiver. You can also add audio from a variety of audio sources when editing a video tape. See your VCR's instruction manual if you need help. [. . . ] Select WIDE mode if you have front and rear speakers and a large center speaker. With the WIDE mode, you can take full advantage of Dolby Surround sound. Compared with the former Dolby Surround system, Dolby Pro Logic Surround improves sound image by using four separate channels: off-screen audio effects, on-screen dialog, leftto-right panning, and music. These channels manipulate the sound to be heard and enhance the action as it happens on the screen. [. . . ]