User manual SONY SU-29

[. . . ] If the Tabletop Stand is installed at an angle, it may topple over and cause injury or property damage. If you install the Tabletop Stand on an unstable surface, it may lose its balance and topple over or fall off. This may cause injury or property damage. Be sure to take measures to prevent the stand from toppling over. [. . . ] Do not lean on or hang from the Tabletop Stand. If you block the ventilating holes on the Display Unit by covering the top of the Tabletop Stand with a cloth or the like, the Display Unit may become overheated and this may cause a fire. Be sure to carry the stand in the manner shown in this manual. If you stumble over the Power Cord or the Display Interface Cable, the Tabletop Stand may topple over and cause injury. Do not carry the Tabletop Stand with Display Unit installed on it. Be sure to remove the Display Unit before attempting to carry the Tabletop Stand. If you fail to do so, the Display Unit may fall and cause bodily injury. If the following precautions are not observed, there is a possibility that the user will suffer injury or that property damage will occur. Do not install equipment other than the specified product. This Tabletop Stand is designed for use with the specified product. If you install equipment other than the specified product, it may fall and cause injury or property damage. Be sure that two or more persons hold the parts during this procedure. Tighten the 10 countersink screws once again after screwing them temporarily. Be sure to hold the stand firmly and keep it stable. â· When you use an electric driver to tighten screws, tightening torque must be approx. If you use impact drivers or electric drivers with the tightening torque other than 2. This may destroy parts or screws, cause the Main Bracket to drop off from the stand, leading to any injury. Be sure to complete the installation before connecting the Power Cord to the wall outlet. If you allow the Power Cord to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock. If you stumble over the Power Cord or the Display Interface Cable, the stand may topple over, and this may result in injury. 2 Be sure that two or more persons hold the right and left edges of the top and the under sides of the Display Unit while fitting the hooks on the rear of the Display Unit into the holes on the fixtures of the stand. Then confirm that the hooks on the rear of the Display Unit are completely inserted into the four holes of the fixtures. [. . . ] 3 Slide the Display Unit straight downward until it snaps on. Be sure to keep the Tabletop Stand stable while installing the Display Unit. Attach the Display Unit to the stand with the two securing screws. 2 Draw the Power Cord and the Display Interface Cable through the cable clamper and fix them. [. . . ]