User manual SONY SU-B460S

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced with the same rating of fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with the same rating of fuse, otherwise the circuit should be protected by a 13 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Connect the AC adapter (mains adaptor) to an easily accessible AC power outlet (mains socket). Moisture may condense inside and may cause TV malfunction. Do not coil the AC power cord (mains lead) around the AC adapter (mains adaptor). The core wire may be cut and/or it may cause a malfunction of the TV. Do not touch the AC adapter (mains adaptor) with wet hands. If you notice an abnormality in the AC adapter (mains adaptor), disconnect it from the AC power outlet (mains socket) immediately. The set is not disconnected from the AC (mains) source as long as it is connected to the AC power outlet (mains socket), even if the set itself has been turned off. Be sure that two or more persons do the installation work. Be sure that two or more persons install the TV on the TV Stand. If one person does the installation work alone, this may result in an accident or injury. Be sure to install the TV securely following the instructions. If the TV is not installed securely, it may fall and cause injury. If the following precautions are not observed, injury or property damage may occur. Be careful not to injure your hands or fingers while assembling. Do not move the TV Stand with holding the Neck section. Be careful not to hurt your fingers or hands when installing the TV. Do not install any equipment other than the specified product. This TV Stand is designed for use with the specified product only. If you install equipment other than specified, it may fall or break, and cause injury. Illustrations used in this manual show of the KDL-46NX71s, unless otherwise stated. If you are not going to use the TV Stand for a long time, be sure to disconnect the TV Stand from the wall outlet (mains). To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. [. . . ] 3 Tie the wood screw and the machine screw with a strong cord (not supplied). Connect the TV with an HDMI jack (socket) to the TV Stand using an HDMI cable. By connecting Sony "BRAVIA" Sync-compatible components using HDMI cables, operation can be simplified when you set the Control for HDMI function for the TV. ) transmitted from an HDMI jack (socket) may be suppressed by the connected component. [. . . ]