User manual SONY SU-FL71M

[. . . ] L LINE IN (OPT) jack M MIC (PLUG IN POWER) * jack *There is a tactile dot beside the MIC (PLUG IN POWER) jack. N REC (record) switch O HOLD switch (at the rear) P i/LINE OUT jack The display window of the recorder A Character information display Displays the track, group, or disc name*, date, error messages, track numbers, etc. *Names appear only with MDs that have been labeled. B Group indication C Disc indication Shows that the disc is rotating for recording, playing or editing an MD. D REC indication Lights up while recording. E SYNC (synchro-recording) indication Lights up while synchro-recording. F Play mode indication Shows the play mode of the MD. G Level meter Shows the level of the MD being played. [. . . ] Turn the control repeatedly to adjust the bass or treble. To switch "B" and "T": Press SOUND for 2 seconds or more. To switch "SOUND 1" and "SOUND 2": Press SOUND for a short time. Press x to enter. 1 2 3 3 4 Press DISPLAY for 2 seconds or more during playback. Turn the control repeatedly until "SPEED" flashes in the display, and then press x to enter. The recorder changes to speed-setting mode. Turn the control repeatedly to select the playback speed. "+" shows the normal speed and the cursor shows the playback speed you are selecting. "S" appears in the display when the speed is changed. 4 To cancel the Digital Sound Preset · On the recorder Select "SOUND OFF" in step 3. · On the remote control Press SOUND repeatedly until nothing appears in the display. Notes · Digital Sound Preset becomes inoperative when the "AUDIO OUT" parameter for the i/LINE OUT jack is set to "LINE OUT". Notes 3 4 · "NAME FULL" appears when you try to enter more than 1, 700 characters on a disc. Enter a shorter name for the track, group, or disc, or set the "LP Stamp" setting to "Stamp OFF" so that "LP:" is not be added at the beginning of the track name. · When labeling a disc which has been recorded using the group function, make sure group mode is on in order to prevent the group management information from being overwitten by mistake. · If you enter the symbol "//" between the characters in disc names such as "abc// def, " you may be unable to use the group function. 5 6 Turn the jog dial until "EDIT" flashes in the display, and then press to enter. Turn the dial until the following item appears in the display, and then press to enter. When labeling a track: " : Name" When labeling a group: " : Name" When labeling a disc: " : Name" The cursor flashes in the letter input area and the track, group, or disc is ready to be labeled. The cursor shifts from the letter input area to the character palette. Select a letter with the 5-way control key and press N to enter. The selected letter appears in the letter input area and the cursor moves to the next input position. The buttons used for character input and their functions are listed below. Labeling recordings On the recorder 1 2 Insert a disc and do the followings. To label a track: Start playing or recording the track you want to label, and then label the track while the recorder is playing or recording. [. . . ] You tried to enter a total of more than 1700 letters for track or disc names. BLANKDISC : You tried to play an MD with no recording on it. NO COPY : You tried to make a copy from a disc that is protected by the Serial Copy Management System. You cannot make copies from a digitally connected source which was itself recorded using the digital connection. Use the analog connection instead. BUSY : You tried to operate the recorder while it was accessing the recorded data. Wait until the message goes out (in rare cases, it may take a few minutes). Data Save : The MD recorder is recording information (sounds) from the memory to the disc. [. . . ]