User manual SONY SU-LW1

[. . . ] to Customers Sufficient expertise is required for installing this product. Be sure to subcontract the installation to Sony dealers or contractors and pay adequate attention to safety during the installation. Sony is not liable for any damages or injury caused by mishandling or improper installation. Your Statutory Rights (if any) are not affected. [. . . ] If the Power Cord or the Display Cable is pinched between the unit and the wall or is bent or twisted by force, the metallic part of the cord or cable may be exposed and cause a short circuit or a break in the cord or cable. Be sure to use the supplied screws and attachment parts properly following the instructions given in this instruction manual. If you use substitute items, the Display Unit may fall, and cause bodily injury to someone or damage to the Display Unit. Be sure to assemble the bracket properly following the instructed procedure explained in this instruction manual. If any of the screws are loose or fall out, the Display Unit may fall, and cause bodily injury to someone or damage to the Display Unit. If you fail to do so, the Display Unit may fall, and cause bodily injury to someone or damage to the Display Unit. Be careful not to subject the Display Unit to shock during installation. If the Display Unit is exposed to shock, it may fall or break apart. Be sure to install the Display Unit on a wall that is both perpendicular and flat. If you fail to do so, the Display Unit may fall and cause injury. If people or objects get tangled in the cables, this may result in injury. Be careful not to hurt your hands or fingers during the installation. Be careful not to hurt your hands or fingers when installing the Wall-Mount Bracket or the Display Unit. The screws needed to secure the Wall-Mount Bracket to the wall are not supplied. Use the appropriate screws for the wall material and structure when mounting the Wall-Mount Bracket. Step 1: Check to see that you have all the items necessary for installation Prepare five or more M6 or equivalent screws (not supplied) and a screwdriver. select screws suitable for the material of the wall. Unpack the carton and check to see that all the following items are included. If you are going to install a KDL-L32MRX1, a KLV-L32MRX1 or a KLV-30MR1, skip Step 2 and go to Step 3. Put both arms and the arm bases B on the arm bases A. 4Secure the arm bases to the Plate Unit using the four screws removed in 2. 5Secure the arms to the arm bases using the four tilt adjusters removed in 1. [. . . ] 2Holding down the base of the Stand, lift up the display slightly, then move it away from the Stand. the display will separate from the Stand. At least two persons must hold and carry the display. At least two persons must work together on this procedure. [. . . ]