User manual SONY SU-P42T2

[. . . ] Sony is not liable for any damages or injury caused by mishandling or improper installation. Your Statutory Rights (if any) are not affected. Please give this manual to the customer after installation. Products by Sony are designed with safety in mind. [. . . ] If you install equipment other than specified, it may fall and cause injury or property damage. If the securing screws are not used, the Display Unit may fall and cause injury. When assembling, lay the packing materials on the floor to avoid damage to the floor. To avoid this, observe the following precautions. ­ If you install the stand on a soft surface such as a mat or a carpet, lay a board over the designated location beforehand. ­ Do not install the stand in a place subject to direct sunlight or near a heater. To keep the stand clean, occasionally wipe the stand with a dry soft cloth. Stubborn stains may be removed with a cloth slightly dampened with diluted detergent. Then wipe the area with a dry soft cloth. Do not use chemicals, such as thinner or benzine, as they damage the finish of the stand. The following instructions are for Sony Dealers only. Be sure to read safety precautions described above thoroughly and pay special attention to safety during the installation, maintenance, checking and repair of this product. Be sure that two or more persons do the installation work. Be sure that two or more persons install the Display Unit on the Tabletop Stand. If one person does the installation work alone, this may result in an accident or an injury. Be sure to assemble the Tabletop Stand securely following the instructions in this manual. If any of the screws are loose or fall out, the Tabletop Stand may lean and topple over, or the Display Unit may fall. This may cause injury or property damage. Be careful not to hurt your hands or fingers when assembling the Tabletop Stand. Be careful not to hurt your hands or fingers when assembling the Tabletop Stand or when installing the Display Unit. Be sure to install the Display Unit securely, following the proper procedure. If the Display Unit is not installed securely, it may fall and cause injury. [. . . ] If you fail to do so, the Tabletop Stand may topple over during an earthquake and cause injury or property damage. Prepare a commercially available rope or chain and wall anchor bracket beforehand. 1 Secure the wall anchor bracket to a solid wall or pillar. 2 Pass the rope or chain through both holes of the anchor attachments and then tighten the other end of the rope or chain to the wall anchor bracket. [. . . ]