User manual SONY SU-PF1

[. . . ] Your Statutory Rights (if any) are not affected. Please give this manual to the customer after installation. Products by Sony are designed with safety in mind. If the products are used incorrectly, however, it may result in a serious injury through fire, electric shock, the product toppling over, or the product dropping. [. . . ] If the Display Unit is not attached securely, it may fall and cause injury. Do not apply weight to the glass or subject it to any kind of impact. Do not apply weight to the glass with your hand when installing the Display Unit. Do not hit the glass with hard objects, such as a screwdriver, etc. Trying to move the Floating Stand alone, or without following the proper procedures, may cause injury. To avoid this, be sure to follow the advice given below. Be sure that two or more persons carry the Floating Stand only after removing the Display Unit. Be careful not to allow your toes to be pinched under the bottom plate or the corner of the glass. This stand is made of tempered glass, but care should be taken. Do not scratch or poke the glass with sharp-edged objects. To avoid this, observe the following precautions. ­ If you install the stand on a soft surface such as a mat or a carpet, lay a board over the designated location beforehand. ­ Do not install the stand in a place subject to direct sunlight or near a heater. To keep the stand clean, occasionally wipe the stand with a dry soft cloth. Stubborn stains may be removed with a cloth slightly dampened with diluted detergent. Then wipe the area with a dry soft cloth. Do not use any type of chemicals, such as thinner or benzine, as they may damage the finish of the stand. Be sure to thoroughly read the safety precautions described above and pay special attention to safety during the installation, maintenance, checking, and repair of this product. Be sure that two or more persons do the installation work. Be sure that two or more persons install the Display Unit on the Floating Stand. If one person does the installation work alone, this may result in an accident or injury. Be sure to keep small children away during the installation. [. . . ] Anchor the stand by using a rope or chain with fastening one end of it to the securing hook and the other end to the wall or pillar. Prepare a commercially available rope or chain and wall anchor bracket beforehand. 1 Secure the wall anchor bracket to a solid wall or pillar. 2 Pass the rope or chain through both holes of the anchor attachments and then tighten the other end of the rope or chain to the wall anchor bracket. [. . . ]