User manual SONY SU-WL700

[. . . ] Be sure to subcontract the installation to Sony dealers or licensed contractors and pay special attention to safety during the installation. Sony is not liable for any damages or injury caused by mishandling or improper installation, or installing any other than the specified product. Your Statutory Rights (if any) are not affected. If the following precautions are not observed, serious injury or death through fire, electric shock, the product toppling over, or the product dropping can result. [. . . ] If any of the screws are loose or fall out, the Wall-Mount Bracket may fall and cause injury or property damage. Be sure to use the appropriate screws for the material of the wall and install the unit securely using four or more screws of 8 mm (11/32 inches) diameter (or equivalent). Do not handle the product with excessive force during cleaning or maintenance. do not apply excessive force on the topside of the Display. If you do so, the Display may fall and cause injury or property damage. If the Display is exposed to water leaks or air current from an airconditioner for a long time, it may cause a fire, an electric shock or a malfunction of the Display. Be sure to use the supplied screws and attachment parts properly following the instructions given in this instruction manual. If you use substitute items, the Display may fall and cause bodily injury to someone or damage to the Display. Be sure to assemble the bracket properly following the instructed procedure explained in this instruction manual. If any of the screws are loose or fall out, the Display may fall and cause bodily injury to someone or damage to the Display. If you fail to do so, the Display may fall and cause bodily injury to someone or damage to the Display. Be careful not to subject the Display to shock during installation. If the Display is exposed to shock, it may fall or break apart. Follow the instructions in this manual referring to the assembly sheet. Be sure to install the Display on a wall that is both perpendicular and flat. If you fail to do so, the Display may fall and cause injury. If people or objects get tangled with cables, this may result in injury or damage to the Display. Do not allow the AC power cord or the connecting cable to be pinched. If the AC power cord or the connecting cable is pinched between the unit and the wall or is bent or twisted by force, the internal conductors may become exposed and cause a short circuit or an electrical break. Be careful not to hurt your hands or fingers during the installation. Be careful not to hurt your hands or fingers when installing the Wall-Mount Bracket or the Display. The screws needed to secure the WallMount Bracket to the wall are not supplied. [. . . ] Make sure that the two arms of the Mounting Bracket are screwed in securely. Hold the Display securely with both hands, and gently align it on the Base Bracket AB referring to the paper template L. Pull the bottom of the Display forward slightly to make sure that it is securely attached to the Base Bracket. If there is any movement, it is not fixed correctly, and the procedure should be performed again. [. . . ]