User manual SONY SU-XFQ005

[. . . ] Be sure to subcontract the installation to Sony dealers or licensed contractors and pay special attention to safety during the installation. Sony is not liable for any damages or injury caused by mishandling or improper installation. Your Statutory Rights (if any) are not affected. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. [. . . ] Do not expose the TV to rain or moisture. If the TV is exposed to water leaks or air current from an air-conditioner for a long time, it may cause a fire, an electric shock or a malfunction of the TV. Never place the TV in hot, humid or excessively dusty places, or in the place where the TV is subjected to mechanical vibrations. If you do so, it may cause a fire or an electric shock. If you use the TV installed on the Wall-Mount Bracket for a long time, the wall behind or above the TV may become discolored or the wallpaper may come unstuck, depending on the material of the wall. If the Wall-Mount Bracket is removed after installing it on the wall, the screw holes are left. If you have routed 300-ohm feeder cables behind the wall, we recommend that you change them to 75ohm coaxial cables. If it is necessary to continue to use 300-ohm feeder cables, be sure there is sufficient space available between the TV and the feeder cables behind the wall before installing. Consult your licensed contractor regarding an appropriate location (free from radio noise, etc. Magnet influence This TV contains a strong magnet in the speaker unit which generates magnetic influence. Keep any items that are susceptible to magnetic influence away from the TV speaker. Step 1: Checking the parts required for the installation Prepare a Phillips screwdriver and the appropriate screws (four or more M8 (or equivalent) screws, not supplied), depending on the material of the wall, beforehand. Place the paper template on a perpendicular, flat wall and decide on the installation location. Tape the supplied 3 sheets of the paper template together with commercially available adhesive tape. for details , refer to the instructions printed on the paper template. Allow for suitable clearance between the TV and the ceiling and protruding parts of the wall as shown in the diagram below. Note If you intend to route the cables in a wall, make a hole in the wall beforehand to make sure that the cables can be drawn into the wall. If you intend to route the cables in the wall, also determine the position of the cable hole and bore a hole in the wall. WARNING The wall that the TV will be installed on should be capable of supporting a weight of at least four times that of the TV (page 16). Make sure of the strength of the wall the TV will be installed on. Step 3: Installing the Plate Unit on the wall 1 Fix the Plate Unit to the wall using four or more M8 (or equivalent) screws (not supplied). Select at least four screw holes with the same mark shown in the diagram below, and tighten the screws securely so that they will not come loose. [. . . ] When sliding the Mounting Rack, make sure that the woofer speaker is securely connected to the TV. Note If you fail to slide the woofer speaker completely in step 2, the woofer speaker connector locating at the center bottom of the rear side of the TV and ventilation holes will be blocked resulting in product damage. Connect the mains lead and the connecting cable(s) supplied with the TV to the TV. When you route the lead and the cable in the wall, feed them through the hole you bored (page 17). [. . . ]