User manual SONY SU-XTQ005 DATASHEET

[. . . ] Please give this manual to the customer after installation. Products by Sony are designed with safety in mind. If the products are used incorrectly, however, it may result in a serious injury through fire, electric shock, the product toppling over, or the product dropping. Be sure to observe the precautions for safety to prevent such accidents. [. . . ] This stand is made of tempered glass, but care should be taken. Do not scratch or poke the glass with sharp-pointed objects. Do not install any equipment other than the specified product. This stand is designed for use with the specified product only. If you install equipment other than specified, it may fall or break, and cause injury. If the TV is not installed securely, it may fall, or the stand may topple over, and cause injury. Do not apply weight to the glass or subject it to any kind of impact. Do not apply weight to the stand with your hand when installing the TV. Do not hit the stand with hard objects, such as a screwdriver, etc. To avoid this, observe the following precautions. ­ If you install the stand on a soft surface such as a mat or a carpet, lay a board over the designated location beforehand. WARNING If you allow the mains lead to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock. If you stumble over the mains lead or the connecting cable, the stand may topple over and cause injury. 1 Pull out the cable covers for the rear side of the TV from the Floating Stand. Decide on the installation location and lay the stand down before installing the TV. Since the TV is heavy, it is recommended that you decide on the installation location and lay the Floating Stand down before installing the TV. Note Do not push or pull the Floating Stand while it is on the floor. Slide your finger into the hole at the bottom of the Floating Stand and detach the cable cover. Position the rear panel on the pillars and secure on each side with the supplied rear panel securing screws. Insert the TV carefully so that the dowels of the Floating Stand fit into the guides of the TV. Do not hold the transparent part locating at the lower part of the TV, otherwise your hands may be pinched when installing the TV on the stand. Hold the TV from its front side as shown above in the illustration. [. . . ] If you need to adjust the sound quality (bass frequencies) after installation, change the distance between the stand and the wall or adjust the woofer level setting from the TV's menu option. See the instruction manual of the TV for more details on adjusting the sound quality. 3 Place all cable covers back in their positions. Align the outside of the cable cover with the groove of the pillar, and then give the cable cover a slight press toward the glass shelf to fit it in position. [. . . ]