User manual SONY SU-XWQ005

[. . . ] Be sure to read this instruction manual thoroughly and use the product correctly. Be sure to keep this instruction manual available for future reference. for Sony Dealers Sufficient expertise is required for installing this product. Be sure to read this instruction manual thoroughly to do the installation work safely. [. . . ] If a person or object happens to hit the protruded corner or side of the Display Unit, this may cause injury or property damage. Do not handle the product with excessive force during cleaning or maintenance. do not apply excessive force on the topside of the Display Unit. If you do so, this may cause injury or property damage by causing the Display Unit to fall. If you do so, the Display Unit may be exposed to air currents from the air-conditioner. If you use the Display Unit installed on the Wall-Mount Bracket for a long time, the wall behind or above the Display Unit may become discolored or the wallpaper may come unstuck, depending on the material of the wall. If the Wall-Mount Bracket is removed after installing them on the wall, the screw holes are left. If you have routed 300 ohm feeder cables behind the wall, we recommend that you change them to 75 ohm coaxial cables. If it is necessary to continue to use 300 ohm feeder cables, be sure to confirm that sufficient space is available between the Display Unit and the feeder cables behind the wall before starting the installation. Consult your contractor on an appropriate installation location where the Display Unit suffers no radio noise before starting the installation. Be sure to subcontract the installation to Sony dealers or contractors and pay adequate attention to safety during the installation. Step 3: Install the Plate Unit on the wall Align the unit so that it is exactly level. Screw hole to be used for temporarily attaching the bracket. Screw the Plate Unit to the wall temporarily and align the position of the Plate Unit so that it is exactly level. Be sure to use the appropriate screws, depending on the material and structure of the wall. Fix the Plate Unit to the wall using eight or more M8 or the equivalent screws (not supplied). 1 1Be sure to tighten the screws securely so that they will not come loose. We recommend using the screw hole locations specified in the diagram on the left when attaching the Plate Unit temporarily. If the Plate Unit cannot be attached securely enough, use additional screws. Be sure to confirm that the Plate Unit is securely fixed to the wall. 1Take out the screws from the right and left sides of the arm base. Then choose the notch corresponding to the desired angle (0, 5, 10, 15 or 20 degrees) and fit the arm base to it. [. . . ] Be careful not to allow the cords and cables to get hung up when removing the Display Unit. Be careful not to hurt your hands or fingers when removing the Display Unit. 0 kg (17 lb 10 oz) Design and specifications are subject to change without notice. ("Sony") warrants this product against defects in material or workmanship, subject to any conditions set forth as follow: 1. [. . . ]