User manual SONY SU32FD1

[. . . ] Should the battery be swallowed, consult a doctor immediately. ADVARSEL!Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af samme fabrikat og type. Levér det brugte batteri tilbage til laverandøren. ADVARSEL Lithiumbatteri - Eksplosjonsfare. [. . . ] page 15b) EXIT ME N U ( Y E Scv) cP A G E 1 5 ( N E X TcV P R E Vcv) SETUP NAVI C A M E R AcT A P E STORE DATA ( Y E Scv) E X I T M E N U ( Y E Scv) DOWN/OFF buttona) UP/ON buttonc) a) Set the cursor to the page number and press the UP/ON or DOWN/OFF button. b) The menu configuration differs according the camera head's switch settings, the connected VTR, and the type of input signal. A 15-page configuration results when all of the advanced menu pages are displayed. c) Set the cursor to EXIT MENU and press the UP/ON button. Chapter 4 Viewfinder Screen Indications and Menus 53 Viewfinder Normal Indications During normal operation, the following items can be indicated in the viewfinder. 1 VTR operation status indication a), b) 2 TAKE/CUE indication a) 3 Recording time or time data indication a), b), c) 4 NG indication a) 5 Clip mode indication a) 6 Clip remaining indication a) 7 Status display area 8 EZ FOCUS indication 9 LOW LIGHT indication c) 0 Camera microphone output indication c) qa Audio recording level indicators a), b), c) qs Tape remaining indication a), b), c) a) b) c) d) REC TAPE NEAR END TAKE TCG 12:34:56:00 W:A NG AUTO BLACK SKIN CLIPM -OKEVS 198 F5. 6 DRP 18dB EZ FOCUS 56ND :LOW LIGHT 99 04 01 SS :1/100 10:00 AM 30-25 BATT:14. 4V qd VTR warning indication a), b) qf White balance indication c) qg SK/N DTL indication c) qh EVS indication qj Lens f-stop indication c) qk Gain indication c) ql Filter setting indication c) w; Clock indication a), b), c), d) wa Voltage/error indication ws Shutter setting indication c) Displayed only when a DSR-1/1P is connected. Displayed only when a PVV-3/3P is connected. Whether or not to display can be selected by menu setting. This is recorded over the picture being shot. The significance of each of the indications shown in the figure is as follows. 1 VTR operation status indication This indicates the VTR's current operation status (REC, PLAY, etc. ). 2 TAKE/CUE indication This displays a TAKE or CUE indicator when using the ClipLink function and recording with the DSR-1/ 1P. TAKE: When recording in Mark mode, this indication appears when a Mark IN point is set and disappears when the next Mark OUT point is set. CUE: When recording in Cue mode, this indication appears for about 1 second when a cue point is set. 3 Recording time or time data indication This shows the following values. Asking whether you will continue shooting in ClipLink mode or not when the cassette contains ClipLink data. (The indication disappears when you press the ClipLink CONTINUE button on the DSR-1/ 1P or start the next shooting without pressing it. ) At back space editing in ClipLink mode, capacity for only 1 to 3 index pictures remains. Impossible to record any more clip shots. qh EVS indication This appears when the EVS (Enhanced Vertical definition System) function is enabled. (See page 84. ) qj Lens f-stop indication This shows the f-stop of the lens. Note MP TAPE CLIP DATA ERR AUDIO 48kHz?(4 flashes/s) Depending on the lens being used, this indication may differ slightly from the actual f-stop on the lens. qk Gain indication This shows the gain value, and the settings of the HYPER GAIN switch and the DPR (Dual Pixel Readout) function (see page 64) as shown in the following table. Example indication 18dB DPR 18dB Meaning Gain setting is 18 dB. In this case the DPR function approximately doubles the gain (an increase of 6 dB) over the current gain setting (in this case 18 dB). The HYPER GAIN switch is in the ON position. In this case the hyper gain function increases the gain by a factor of about 60 or 120 with respect to 0 dB regardless of the current gain setting (that is, increased to 36 or 42 dB). AUDIO 32kHz?(4 flashes/s) ERROR:91-13F CLIP CONT? Chapter 4 Viewfinder Screen Indications and Menus HYPER CLIP NEAR END CLIP END ql Filter setting indication This shows the setting of the FILTER control. Indication Filter setting 1 (3200K) 2 (5600K + 1/8ND) 3 (5600K) 4 (5600K + 1/64ND) 3200 56ND 5600 56ND qf White balance indication The following indications appear. Indication Meaning EZ ATW W:A W:B W:P W:M Operating in EZ mode (The ATW function is selected. ) The ATW function is selected. (The ATW button was pressed and the indicator is lit. ) White balance memory A is selected. [. . . ] When editing, begin by transferring only the Index Pictures and the ClipLink log data to the EditStation's hard disk. You can also transfer OK scenes only ("NG" scenes are skipped). Appendix When using a tape recorded by a DVCAM camcorder to transfer digital (video/audio/time code) signals at four times normal speed from the DSR-85/85P Digital Videocassette Recorder to the ES-7 EditStation for editing purposes, there must be about at least 40 seconds of recording on the tape before the IN point. To perform editing without problems, it is recommended that you pre-record at least 40 seconds of color bar signals at the beginning of the tape. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1) The ClipLink system is a video production system which uses the cassette memory function. 102 Appendix ClipLink Operation Flow The following is a detailed description of how to use the ClipLink function during the video production process. Example System Configuration The following illustration shows the optimum system configuration for using the ClipLink function. [. . . ]