User manual SONY TA-3200F service manual

[. . . ] The "On-Screen Operations" section describes how to operate the amplifier using the remote to manipulate the on-screen display on your TV screen. The remote lets you perform almost all of the amplifier operations. You can also control the amplifier without the remote. The "Front Panel Operations" section describes how to operate the amplifier using the front panel controls and remote short-cut buttons. [. . . ] Once you customize the sound fields, they are stored in memory unless the amplifier is unplugged for about two weeks. To change a customized sound field, make new adjustments to the sound field. Click a sound field genre, then click MODE repeatedly until the mode you want appears. To turn off the sound fields You can adjust the bass sound or listen to the music directly in the SOUND FIELD SELECT menu to increase the bass sound , click BASS BOOST ON. To listen to the music without any audio effects, click DIRECT PASS ON. Even if you set SOUND FIELD to OFF, these functions are effective. To get the most out of the PRO LOGIC sound fields, also see the chapter "Dolby Pro Logic Surround Setup" on page 18. The EFFECT parameter allows you to adjust the overall presence of the sound field. You can adjust the tone of all sound fields. The delay time is the time lag between the surround sound output from front and rear speakers. You can make the surround sound more effective by delaying the output from the rear speakers. Keep the remote pointed horizontally at the IR sensor until the code is registered. Click the button where the IR code was registered, then click START. If the mains lead is disconnected for about two weeks, the registered IR codes will be cleared. " will appear on the TV screen the next time you turn on the amplifier. The power switch on some air conditioners use two independent IR codes, even when there is only one switch. If you cannot turn the air conditioner off with the IR code registered for the on/off switch, repeat the procedure and register the on and off IR codes separately. The amplifier may not be able to register IR codes with special waveforms produced on some remote controls. The Index functions let you specify icons for each function button and names up to 8 characters long for each function button and preset radio station. To erase another code, repeat steps 2 and 3. 2 Click the icon you want from the icon menu, then click RETURN. Create the new name by clicking each character. [. . . ] Design and specifications are subject to change without notice. To obtain the best possible surround sound, select one of the four centre modes (WIDE, NORMAL, PHANTOM or 3 CH LOGIC) according to your speaker system. Variable of sound that composes sound image, such as tone or delay time. You can customize the pre-programmed sound fields by adjusting parameters to suit your listening situation. [. . . ]