User manual SONY TA-E1

[. . . ] ⷠDo not place the preamplifier near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. ⷠDo not place anything on top of the cabinet that might block the ventilation holes and cause malfunctions. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. Before connecting other components, be sure to turn off and unplug the preamplifier. [. . . ] When connecting a balanced cord, be sure to insert the plugs firmly in the jacks. If the plugs are not connected firmly, noise may be produced. Before connecting the AC power cord of this preamplifier to a wall outlet: · Make sure that the power switch on the preamplifier is in the off position. Connect the supplied power cord to the AC IN terminal on this unit. (USA/Canadian model only) The supplied power cord has a 3-pronged grounded plug. If you are using a 3-pronged grounded outlet, the plug can be inserted directly into the outlet. However, if the socket is a 2-pronged grounded outlet, use the supplied AC power plug adapter or a commercially available AC power plug adapter. When using a grounded outlet (the inlets are different sizes) Use the supplied AC power plug adapter. (European model only) Connect the supplied power cord to a wall outlet. Noise may be caused by an electrical potential difference on the ground circuit*. In this case, use the supplied AC power plug adapter and be careful not to connect the ground lead to anything. * Although the ground of the domestic outlet is normally a safety ground, a slight electrical potential difference may be produced, depending on the outlet. Therefore, use of the supplied 3-pronged power cord may lessen the quality of the audio signal or may produce humming noise. We recommend that you connect this unit directly to a wall outlet. If you must use a multi-outlet tap, or extension cord, be sure to use one capable of handling high current (at least 10 A) or one designed for office use. This chapter provides information about the locations and functions of the buttons and controls on the front and the various jacks on the rear panel. Before you turn on the preamplifier, make sure that you have turned the VOLUME control to the leftmost position to avoid damaging your speakers. 2 Power indicator Lights red for 12 seconds when preamplifier is turned on, and then lights green. DAT deck, tape deck 1 MD deck BALANCED LINE SACD player CD player LINE 1 LINE 2 Turn to light After selecting the component, turn on the component you selected and play the program source. The indicator lights when the tape monitor is on and goes out when the tape monitor is turned off. [. . . ] Should any problem persist, consult your nearest Sony dealer. There's no sound or only a very low-level sound is heard. / Check that all components are connected securely. / Make sure that you've selected the correct component on the preamplifier. [. . . ]