User manual SONY TA-FE570

[. . . ] Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. ­ keep the turntable as far from the speakers as possible. [. . . ] Be sure to make connections firmly to prevent hum and noise. ⷠWhen connecting an audio connecting cord, be sure to match the R (right) and L (left) jacks of the amplifier to the R and L jacks on the other components. Do not leave the remote near an extremely hot or humid place. ⷠDo not drop any foreign object into the remote casing, particularly when replacing the batteries. ⷠIf you don't use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion. Here you learn how to connect your audio components to the amplifier. Use the configuration above to connect the OUTPUT and INPUT jacks of: Audio connecting cord (not supplied) (2 for each tape deck, DAT deck, or MD deck; 1 for other components) The jacks on the TA-FE570 are shown in the following illustrations. If your tuner is equipped with an EON CONTROL OUT terminal, connect it to the EON CONTROL IN terminal on the amplifier to allow use of the EON (Enhanced Other Networks) function of the RDS (Radio Data System) (see page 8). Here you learn how to connect speakers to the amplifier. Before connecting, remove the caps from the speaker terminals. Connect the mains lead from this amplifier and from your audio/video components to wall outlets. You can power other components through AC OUTLET on the amplifier (except for U. By connecting other audio components to AC OUTLET on the amplifier, you can supply power to the connected components through the amplifier and turn them all on or off when you turn the amplifier on or off. Twist the stripped ends of the cord about 15 mm. be sure to match the speaker cord to the appropriate terminal on the components: + to + and ­ to ­. If the cords are reversed, the sound will be distorted and will lack bass. Make sure that the total power consumption of all components connected to the outlets on the amplifier does not exceed 100 watts. Do not connect electrical home appliances such as an electric iron, fan, TV, or other high-wattage appliances to these outlets. [. . . ] ⷠPoint the remote towards the remote sensor on the front of the amplifier. ⷠThe remote is too far from the amplifier. Change speaker positions or room conditions to eliminate obstructions in sound path. [. . . ]