User manual SONY TA-E1000E

[. . . ] You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. Before operating the control amplifier, check that the operating voltage is identical with your local power supply. The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. If you are not going to use the control amplifier for a long time, be sure to disconnect the control amplifier from the wall outlet. [. . . ] Uses 3D sound imaging to create an array of virtual rear speakers positioned higher than the listener from a single pair of actual rear speakers. Reproduces the sound characteristics of the "Cary Grant Theater" and creates 5 sets of virtual speakers surrounding the listener (at approximately a 30° angle of elevation) from a single pair of actual rear speakers. adds the 3D sound imaging of VIRTUAL MULTI DIMENSION to CINEMA STUDIO B. Reproduces the sound characteristics of the "Kim Novak Theater" and creates 5 sets of virtual speakers surrounding the listener (at approximately a 30° angle of elevation) from a single pair of actual rear speakers. adds the 3D sound imaging of VIRTUAL MULTI DIMENSION to CINEMA STUDIO C. Reproduces the sound characteristics of the scoring stage and creates 5 sets of virtual speakers surrounding the listener (at approximately a 30° angle of elevation) from a single pair of actual rear speakers. Uses 3D sound imaging to create 3 sets of virtual rear speakers from the sound of the front speakers without using actual rear speakers. Uses 3D sound imaging to create 1 set of virtual rear speakers from the sound of the front speakers without using actual rear speakers. Uses 3D sound imaging to create virtual rear speakers from the sound of the front speakers without using actual rear speakers. Reproduces the sound characteristics of the "Cary Grant Theater" and creates 5 sets of virtual speakers surrounding the listener at a 30° angle of elevation from the sound of the front speakers without using actual rear speakers. Reproduces the sound characteristics of the "Kim Novak Theater" and creates 5 sets of virtual speakers surrounding the listener at a 30° angle of elevation from the sound of the front speakers without using actual rear speakers. Since the LFE signal is not recorded in all parts of the input signal the bar indication will fluctuate (and may turn off) during playback. WOOFER Lights when the sub woofer selection is set to "YES" and sound is being output from the sub woofer. 8 PRO LOGIC Lights when this unit applies Pro Logic processing to two channel signals in order to output the center and surround channel signals. 9 DTS Lights up when DTS signals are input. When playing a DTS format disc, be sure that you have made digital connections and that DIGITAL/ANALOG is NOT set to ANALOG (see 5 on page 13). You may hear some noise when starting playback from a DTS format LD or CD. 0 MPEG Lights when MPEG signals are input. ¡ RF Lights when Dolby Digital (AC-3) RF signals are input from the LD (LD/DVD) player. TM AC-3 Lights when Dolby Digital (AC-3) signals are input. Playback channel display The display shows which channels are being played back and which speakers are being used. ) light to show the channels being played back. [. . . ] / Move your TV away from the audio components. Hold down AUDIO SPLIT for more than 2 seconds to cancel the function and restore both audio and video to the selected video component. / Remove any obstacles in the path between the remote and the control amplifier. / Replace all batteries in the remote with new ones, if they are weak. [. . . ]