User manual SONY TA-N9000ES

[. . . ] This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Use a CONTROL A1 cord (supplied) to connect the SLINK CTRL A1 jack on this unit to the S-LINK CTRL A1 jack on the TA-E9000ES AV Control Amplifier. When the TA-E9000ES AV Control Amplifier is set to standby mode, this unit will also switch to standby mode. If you are using more than one TA-N9000ES power amplifier, use additional CONTROL A1 cords to connect them in series. Before connecting the AC power cord of this control amplifier to a wall outlet: · connect the speakers. Connect this unit's AC power cord to a wall outlet. note We recommend that you connect this unit directly to a wall outlet. If you must use a multi-outlet tap, or extension cord, be sure to use one capable of handling high current (at least 10 A) or one designed for office use. About the power cor d This unit's power plug has a mark (· ⷠ) on the ground blade to enable you to match polarity when making power connections and achieve high quality musical reproduction. Insert the marked blade of the power plug into the side of the outlet with the larger opening (the grounded side). This chapter explain the names and basic operations of the buttons and controls located on the front panel. 1 U switch Press to turn the power amplifier on and off. STANDBY indicator Blinks momentarily after U is pressed to turn the unit on, then goes out to indicate that the unit is ready. If you make Control A1 connections between the power amplifier and the TA-E9000ES AV Control Amplifier, this indicator lights red when control amplifier is set to standby mode. Blink if you select a mode that cannot be used. Signals input to the FRONT or REAR INPUT jacks are output from the FRONT (L/R) BTL speaker connections. Signals input to the FRONT or REAR INPUT jacks are output from the FRONT (L/R) BTL speaker connections. Signals input to the CENTER INPUT jacks are output from the CENTER SPEAKER jacks. Signals input to the EXTRA 2ch INPUT jacks are output from the FRONT (L/R) BTL speaker connections. FRONT (L/R) FRONT (L/R) + CENTER FRONT (L/R) + REAR (L/R) FRONT (L/R) + CENTER + REAR (L/R) Signals input to the EXTRA 2ch INPUT jacks are output from the FRONT (L/R) speakers. WARM UP Set OPERATION to this position (instead of turning the power off) to keep the circuitry warm when the power amplifier is not being used. This enables you to enjoy excellent sound quality immediately the next time you use the power amplifier. The warm up mode works the same during both NORMAL and BTL operation. [. . . ] / Move your TV away from the audio components. Wipe them with a cloth slightly moistened with alcohol. Before connecting other components, be sure to turn off and unplug the power amplifier. Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. [. . . ]