User manual SONY TC-630

[. . . ] Record/playback connector tREC/PBl @ lf an amplifier has the same type connector as that on the TC-630, the record/ playback connections can be made with a single cable, SONY Connector Cable RC-2 (optional). To use the input of this connector, set the INPUT SELECTOR to the AUX position. Note: Do not plug this connector and the AUXILIARY I NPUTS simuJtaneously. Ground terminal IGNDI @ Connect the ground wire of the turntable or other equipment of a sound system to this terminal. [. . . ] This suppressor does not affect response frequencies below 9 kHz allowing f ull pass-band. When the recorder is on, the pilot lamp above the switch lights green. Bass tone control IBASSI @ Turn this knob clockwise to increase the low-frequency response in both channels. This knob regulates the level of either leÍt or right channels to produce the optimum This knob regulates the sound level of both channels of the speakers or of the head- This selector switches the speakers of either the lid speakers or the external speakers connected to the associated outputs. For monophonic sound reproduction, set the selector to either L or R position ; with L position, monophonic L sound is applied to both channel speakers. With R position, monophonic R sound is applied to both channel speakers. Power amp power switch TPowER POWER-AMPI e) Turns on or off the power amplifier section of the TC-630. When the power amplifier is on, the pilot lamp above the switch lights Complete the connections between the TC-630, speakers and sound sources. Turn on the two POWER SWITCH oÍ When high-frequency noise such as record While using the TC-630 as an ampliÍier of disc or fm/am programs, if a tape is placed on the recorder, keep a little slack Because, if the tape is threaded tightly, the wire lever (which is coupled with the automatic Balancing the speakers The feeling of direction and depth that stereophonic sound produces is greatly affected if the levels of both channels are Place an empty reel on the right reel spindle (TAKE-UP REEL SPINDLE) and a full reel on the left reel spindle (SUPPLY REEL SPIN- Thread the tape from left to right by passing under the head cover and wrap the tape around the hub of the right reel or insert the end of the tape into the reel slot. Rotate the reels a few times to take up the slack of the tape so that the AUTOMATIC SHUT-OFF SWITCH assumes playing Size be used for both supply and take-up. Place the supplied reel caps to keep the reels in place when the TC-630 is used in a vertical position. Position while keeping the RECORD LEVERS to the locked position. To pause the tape while recording, pull the INSTANT STOP LEVER towards you. Tape will be stopped instantly without releasing the RECORD LEVERS. The INSTANT STOP LEVER can also be used as a 'standby' system. Pull the RECORD LEVER to the locked position. Pull the INSTANT STOP LEVER to the locked position. Note: Do not activate the INSTANT STOP LEVER while fast forwarding. At the end of each track, do not rewind the tape. Monophonic playback procedures are the same as the stereo playback except for the While keeping the RECORD LEVERS into the locked position, set the FUNCFWD position. [. . . ] Overlap the tapes to be spliced and make a diagonal cut across the over- Use splicing tape and a pair of scissors. Then place the two diagonal Be careful to make the ends meet, but not overlap. The following will be helpÍul to correct any trouble which may occur with the TC-630. Lf you have any difrlculties that cannot be rectified by going over this guide consult The tape does not move when the FUNGTION SELECTOR is set to the FWD Ln compliance with the safety rules Do not attempt to move the Voltage Selector. [. . . ]