User manual SONY TC-SP55

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This system is equipped with the Dolby* B-type noise reduction system. Here are some of the features you can use with this tape deck when connected with the CMT-SP55MD Micro Hi-Fi component system (see page 4). The tape deck power is tied with the CMT-SP55MD Micro Hi-Fi component system. [. . . ] If the MD is record protected, "C11" and "Protected" appear alternately and the MD cannot be recorded. Remove the MD, then slide the record protection tab to the closed position. With the side you want to play facing up. Press A again to close the cassette tray. You can select your favourite CD tracks with the Programme Play feature, then record the programme on a tape using the Synchro Recording feature. This lets you rearrange the track order while making sure the playback time fits on each side of the tape. Press the track number of the track you want to record. To select track number 11 and higher Press >10 once and then the number buttons of the track number. For example, to select track 32, press >10, 3, and 2. Repeat step 3 to select the tracks to be recorded on the side where recording is to start. "P" appears and the total playing time display changes to "0m00s". Press H on the tape deck to record starting from the front side. You can make an analogue recording of an MD on a tape with the tracks in the same sequence as the original MD. You can also record a programme of favourite tracks. Appears to record on one side or h (or j) to record on both sides. If you select both sides recording and the tape reaches the end of the front side partway through a track, the entire track is recorded again from the beginning of the reverse side. When you start recording from the reverse side, the recording stops at the end of the reverse side even though you select h. When the recording is completed, the CD player and the tape deck stop automatically. When you want to reduce the hiss noise in highfrequency signals recorded at low level, press DOLBY NR after step 10 so "DOLBY NR" appears in the display. Turning DOLBY NR on reduces the noise when playing back these types of signals. Turn FUNCTION on the amplifier until "MD" appears. Press H on the tape deck to record starting from the front side. [. . . ] The system automatically turns on about 30 seconds before the start time and prepares for timer-recording. Recording starts as soon as the system is ready, so recording may start earlier than the preset time. Set the time to stop recording following the procedure in step 4. Do not operate the system from the time the system turns on until the recording starts (about 30 seconds before the preset time). [. . . ]