User manual SONY TC-TX1

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. -- For the tuner CD player -- A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362, (i. [. . . ] Once you have preset the stations, you can quickly tune in your favourite stations. Press TUNING +/­ to display the preset channel number you have decided on. You can use TYPE I (normal), TYPE II (CrO2) and TYPE IV (metal) tapes. When listening to a tape recorded with the Dolby* B-type noise reduction system Dolby noise reduction system reduces tape hiss noise in low-level high-frequency signals. * Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. "DOLBY" and double-D symbol a are trademarks of Dolby Laboratories Licensing Corporation. One Touch Play feature Press ( or 9 when the power is off or you are listening to another source. As long as a tape is in the deck, you will immediately be able to listen to the tape without pressing any other buttons. If a tape is not in the deck, only the power will be turned on. You can record a CD on a tape quickly by using the CD SYNC switch. Use the buttons on the CD player and the cassette deck. Before recording, make sure the tabs on the cassette have not been removed. Find the beginning of the current or succeeding track * The deck stops automatically after repeating the sequence five times. When the track order has been programmed and the total length of the tracks to be recorded is shorter than the length of one side of the tape, the unit automatically operates as follows: When the CD player is paused, the deck continues recording silence until it reaches the end of the front side; then it reverses the tape and starts recording. You can adjust the total recording time to the tape length while making a programme. * Recording always stops at the end of the reverse side. After about 10 seconds, the CD starts playing. When you programme to record on side B, the CD will pause after completing the recording on side A. The deck continues recording silence until it reaches the end of side A, then it reverses the tape and starts recording on side B. Once all of the selected tracks have been recorded, the deck records about 4 seconds of silence and then stops. If the last portion of the track is recorded on the leader at the end of the tape, recording may not be made completely. When programming for side B after pausing at the end of side A, make sure the tracks programmed for side A do not exceed the length of a single side. [. . . ] To clean the cabinet Use a soft cloth slightly moistened with mild detergent solution. To clean the CD When a CD is dirty, clean it with a cleaning cloth. If there is a scratch, dirt or fingerprints on the CD, it may cause a tracking error. While the timer functions, press the POWER switch to turn off the system. [. . . ]