User manual SONY TC-TX333

[. . . ] Complete steps 1 through 4 to hook up your system using the supplied cords. The AU BUS connecting cord is used for exchanging signals between the tape deck and the DHC-MD333. If you do not connect the cord firmly, the tape deck and DHC-MD333 may not operate correctly. The two audio connecting cords are the same, so you can connect A or B using either cord. [. . . ] Inserting the tape when the power is off automatically turns on the tape deck only. Press on the DHC-MD333 to turn on the DHC-MD333 component system before recording. ⷠThe cassette indicator lights up in red when a cassette is inserted and goes off when no cassette is inserted. ⷠWhen you want to reduce the hiss noise in lowlevel high-frequency signals, set DOLBY NR to ON before step 5. ⷠIf the tape reaches the end of the top side during both sides recording, the fadeout feature prevents the track from ending abruptly at the end of the tape (Fade Synchro). The track is recorded again from the beginning of the bottom side. ⷠThe fadeout feature also works when you record on one side only. * This tape deck is equipped with the Dolby B-type noise reduction system. With the side you want to record on facing up You cannot listen to other sources while recording. ⷠWhen you record on both sides, be sure to start from the top side. If you start from the bottom side, recording stops at the end of the bottom side. With manual recording, you can record just the songs you like from a CD, or start recording from the middle of the tape. You can also record a radio programme or MD. If you want to record starting from the bottom side, press ª (for the bottom side) so the indicator on the ª button lights up. * This tape deck is equipped with the Dolby B-type noise reduction system. The cassette indicator lights up in red when a cassette is inserted and goes off when no cassette is inserted. ⷠWhen you want to reduce the hiss noise in lowlevel high-frequency signals, set DOLBY NR to ON before step 5 . ⷠUsing the timer function on the DHC-MD333, you can record radio programmes at a preset time. for details , refer to "Timer recording radio programmes" in the DHC-MD333 component system Instruction Manual. When you set the timer recording, DOLBY NR and DIRECTION mode must be set on the tape deck. With the side you want to record on facing up Before operating the tape deck, check that the operating voltage of your tape deck is identical with the voltage of your local power supply. To prevent a tape from being accidentally recorded over, break off the cassette tab from side A or B as illustrated. [. . . ] Move the tape deck away from the TV or VCR. The mains lead is disconnected from the mains. ⷠMake sure the audio connecting cords are connected correctly (see page 5). The remote supplied with the DHC-MD333 does not function. [. . . ]