User manual SONY TC-TX595

[. . . ] 2 Peel away the seal paper from the back of the system cable adapter and secure the adapter to the DHC-MD373/595. Position the adapter so that it does not interfere with the audio connecting cords. The system cable adapter is used to connect the AU BUS connecting cable for exchanging signals between the tape deck and the DHC-MD373/595. If you do not connect the system cable adapter and the AU BUS connecting cable firmly, the tape deck and DHC-MD373/595 may not operate correctly. [. . . ] You can use TYPE I (normal) or TYPE II (CrO2) tape, since the tape deck automatically detects the tape type. If you select both sides recording and the tape reaches the end of the top side part-way through a track, the entire track is recorded again from the beginning of the bottom side. If you want to record starting from the bottom side, press h (for the bottom side) so the indicator on the h button lights up. * This tape deck is equipped with the Dolby B-type noise reduction system. If the tape reaches the end of the top side part-way through a track, the tape rewinds and the track is recorded again from its start. After that, recording starts with that track from the beginning of the bottom side during both sides recording, or recording stops during one side recording. With the side you want to record on facing up When you press `/1 (power) on the tape deck, only the tape deck turns on. Inserting the tape when the power is off automatically turns on the tape deck only. Press `/1 (power) on the stereo system to turn on the stereo system before recording. â· The cassette indicator lights up in red when a cassette is inserted and goes off when no cassette is inserted. â· When you want to reduce the hiss noise in low-level high-frequency signals, set DOLBY NR to ON before step 5. â· If the tape reaches the end of the top side during both sides recording, the fadeout feature prevents the track from ending abruptly at the end of the tape (Fade Synchro) (DHC-MD313/333 only). The track is recorded again from the beginning of the bottom side. With manual recording, you can record just the songs you like from a CD, or start recording from the middle of the tape. You can also record a radio programme or MD. You cannot listen to other sources while recording. â· When you record on both sides, be sure to start from the top side. If you start from the bottom side, recording stops at the end of the bottom side. * This tape deck is equipped with the Dolby B-type noise reduction system. With the side you want to record on facing up Before operating the tape deck, check that the operating voltage of your tape deck is identical with the voltage of your local power supply. If you want to record starting from the bottom side, press h (for the bottom side) so the indicator on the h button lights up. The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet (mains), even if the unit itself has been turned off. [. . . ] The mains lead is disconnected from the mains. â· Make sure the audio connecting cords are connected correctly (see page 7). The remote supplied with the stereo system does not function. The functions tied with the stereo system, such as CD-TAPE Synchro Recording, do not work. [. . . ]