User manual SONY TC-WE435

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The AUTO indicator lights up continuously after the recording level has been adjusted. Recording level setting remains even after the recording has ended After you have finished recording with the Auto Rec Level function, the AUTO indicator remains on and the recording level setting remains the same. Press ARL or turn REC LEVEL to turn off the AUTO indicator. If you do either of these during recording, recording will continue but with the Auto Rec Level function turned off. The Auto Rec Level function automatically sets the recording level according to the peak signal level of the program source. While the AUTO indicator is flashing, the deck sets the recording level as high as possible without causing distortion. If the signal level rises excessively after the start of recording, the deck gradually decreases the recording level. You can gradually increase the recording level at the beginning of a recording (fade in) or gradually decrease the recording level at the end of a recording (fade out). It is convenient to use this function, for example, when the tape reaches to its end and you don't want the track to be cut off abruptly. You can copy a tape in deck A to a tape in deck B at normal or high speed. Insert a recorded cassette into deck A and a blank cassette into deck B. Make sure the record-protect tabs on the cassette in deck B have not been removed. 2 Start playing the program source and press FADER at the point where you want the fade-in to start. during fadein , the AUTO indicator flashes. When the fade-in has completed, the AUTO indicator goes off. (The AUTO indicator lights continuously if the Auto Rec Level function is on. ) While you're still recording, press FADER at the point where you want the fade-out to start. Recording on the reverse side on deck B starts simultaneously with playback of the reverse side on deck A. Fade-in or fade-out is not possible when the REC LEVEL control is set to 0 (minimum). You can insert a blank space of 4 seconds between the tracks. The blank spaces allow you to locate the start of specific tracks afterwards using the Multi-AMS function (see page 8). You can also use this function to erase unwanted portions on a tape. [. . . ] / There is noise in the space before a track. / You pressed the ) (or 0) button immediately before the beginning of the next track or immediately after the beginning of the current track. The Dolby NR function does not work properly during playback. / The Pitch Control function is on and the frequency characteristics of the sound is altered. [. . . ]