User manual SONY TC-WE835S

[. . . ] 3-866-256-11(1) Stereo Cassette Deck Operating Instructions TC-WE835S TC-WE635 1999 by Sony Corporation Warning To prevent fire or shock hazard, do not expose the unit to rain or moisture. INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] The deck changes to dubbing standby. 4 Select the side from which to start dubbing. To record from The front side The reverse side Press · ª 5 Press PAUSE P on deck B to start dubbing. (Continued) 13 Advanced Recording Operations To stop dubbing During Normal-speed dubbing High-speed dubbing Press p on deck B p on either deck Recording on Both Decks in Succession (Relay Recording) You can make a continuous recording that starts on a cassette in deck A and ends on a cassette in deck B. DIRECTION MODE ª/· z z During high-speed dubbing Only the p button is operative. You don`t have to adjust the recording level or select the Dolby NR during dubbing Dubbing is automatically performed with the same recording level and Dolby NR as the original in deck A. If, however, you want to monitor the sound during normal-speed dubbing, set the DOLBY NR selector to match the tape in deck A (see page 5). U 0 ) 0 ) p · ª R r · p ª P R · r P § § REC r z 1 You can adjust the pitch of the playback on deck A See page 5. Insert blank cassettes into both decks. Make sure that record-protect tabs on the cassettes have not been removed. Adjust the recording level manually, if necessary (see page 7). To record from The front side The reverse side Note If a TV set is placed near the tape deck, noise may occur during high-speed dubbing. In that case, turn the television set off or move it away from the tape deck. 2 3 4 Dubbing only specific portions You can do this only during the normal-speed dubbing. 5 6 1 Press p on deck A at the portion you want to skip. Locate the point you want to resume recording on deck A, then stop the tape. Press PAUSE P on deck B to resume dubbing. 7 2 3 Press · on deck A ª on deck A To stop Relay Recording During Recording on deck A Recording on deck B Press p on deck A p on deck B Note Make sure that · on deck B appears in the display. If it doesn't, press · on deck B once; otherwise, Relay Recording stops when the reverse side of the cassette in deck B finishes. 14 Advanced Recording Operations Recording the Same Source on Both Decks (Simultaneous Recording) You can record the same source on cassettes in deck A and B at the same time. DIRECTION MODE ª/· A+B REC Recording Your Own Program (RMS Dubbing) You can record an RMS program that you've created (see "Creating Your Own Program (RMS Play)" on page 9). This function works only at normal speed. RMS/START HIGH/NORMAL U U 0 0 ) 0 ) ) 0 ) p p · ª R r · p ª P R · r ª R r · p ª P R · r · P P § § § § PAUSE P ª/· PAUSE P ª/· 1 Insert blank cassettes into both decks. Make sure that record-protect tabs on the cassettes have not been removed. Select the Dolby NR (see page 7). 1 2 3 Insert a recorded cassette into deck A and a blank cassette into deck B. Make sure the record-protect tabs on the cassette in deck B have not been removed. Program tracks on deck A (see Steps 1 to 5 on page 9). Press HIGH/NORMAL once to change the tape deck to dubbing standby. Select the side of the tape in deck B you want to record on. To start recording On the front side On the reverse side 2 Select the side(s) to be recorded on. To record on Only one side Both sides Set DIRECTION MODE to A a 3 4 4 5 6 7 Press A+B REC. Adjust the recording level manually, if necessary (see page 7). Select the side you want to start recording from on both decks. To record from The front side The reverse side Press · ª 5 Press RMS/START or PAUSE P on deck B to start RMS Dubbing. To stop RMS Dubbing Press p on deck B. [. . . ] and Canada U. K. , Continental Europe, China and certain countries in Asia Australia Other countries Power requirements 120 V AC, 60 Hz 220 ­ 230 V AC, 50/60 Hz 240 V AC, 50/60 Hz 120/220/230 ­ 240 V AC, 50/60 Hz Power consumption TC-WE835S: 30 W TC-WE635: 22 W Dimensions (approx. ) (w/h/d) Model for U. K. and Australia: 430 × 120 × 310 mm Model for other countries: 430 × 120 × 290 mm (17 × 4 3/4 × 11 1/2 in. ) including projecting parts and controls Mass (approx. ) 4. 3 kg (9 lbs 8 oz) Wow and flutter TC-WE835S: ±0. 13% W. Peak (DIN) Variable pitch range (approx. ) ­30 to +30% Supplied accessories See page 4. Optional accessory Remote commander RM-J910 (except TC-WE835S U. S. A. model) For more information on the availability of the remote commander, contact your nearest Sony dealer. [. . . ]