User manual SONY TC-DD7

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Stop recording Start recording from the reverse side Pause Take out the cassette Distortion and noise in the high-frequency response are reduced to produce highquality sound that can be enjoyed even during playback on other tape decks. After pressing REC r in Step 4 on page 6, turn L R REC LEVEL so that the peak level meters reach the recommended level for the corresponding For type I or tape type. After completing the adjustment, stop type II tape playing the program source, then continue the For type IV tape procedure from Step 5. The Auto Rec Level function automatically measures the peak signal level and adjusts the recording level accordingly. You should adjust the recording level manually with REC LEVEL in the following cases: --The recording level cannot be adjusted properly due to excessive noise in the program source. --The program source level is too low and the recording level does not increase. During a quiet passage in a program source such as classical music, the recording level may not increase for some time. If a high sound level is expected later on in the track, play that portion first so that the right adjustment can be obtained. --The recording level does not decrease for a long time. The Auto Rec Level function may not work properly when you try to record sound produced by a graphic equalizer that has extremely high-level signals. To record with the optimum recording level ⷠTo prevent changes in the recording level after recording starts, press REC r while playing the highest sound level portion of the program source to be recorded. If a TV set is placed near the tape deck, noise may occur during high-speed dubbing. In that case, turn the television set off or move it away from the tape deck. After 4 seconds, P lights up and the tape deck changes to recording pause. If you want to insert a blank space longer than 4 seconds Hold down REC MUTING R as long as you want. After 4 seconds, "REC" flashes faster. When you release REC MUTING R, P lights up and the tape deck changes to recording pause. You can do this only during the normal-speed dubbing. Locate the point you want to resume recording on deck A, then stop the tape. If your CD player has the Peak Search function: By pressing SYNCHRO, you can perform synchrorecording on your tape deck with a Sony CD player connected to the CONTROL A1 connector through an optional monaural (2P) mini-plug cord (connecting cord for CONTROL A1) (see page 4). The monaural (2P) mini-plug cord supports advanced functions not possible with the commander-based CD synchrorecording function on previous models. Further information on the various operations made possible by a monaural (2P) mini-plug cord is provided in the pamphlet attached to this manual. [. . . ] If the tape ends during CD Synchro-Recording on the front side of the tape (· lights up) and DIRECTION MODE is set to a or RELAY Recording of the track ends immediately, the tape direction is reversed, and recording starts again from the beginning of the track. If the tape ends on the reverse side of the tape (ª lights up), CD SynchroRecording stops and the CD player stops playing. To prevent interruption of the recording process, do not press any operation buttons on the CD player during CD Synchro-Recording. ⷠCertain operation buttons on the tape deck are disabled during CD Synchro-Recording. [. . . ]