User manual SONY TC-DD8

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] You can use your Sony stereo receiver's remote to perform RMS programming If your Sony stereo receiver's remote has RMS buttons, do the following steps. 3 Press ( or 9 to select the front or reverse side of the tape, and the number keys (and the >10 key) to specify the tracks. Insert (a) cassette(s) into either deck (or both decks). Make sure that the connections are correct (see page 7). For more information on the availability of Sony stereo receiver remotes with RMS capability, contact your nearest Sony dealer. (Playback on deck B always starts from the front side of the tape. Before you set the timer in Step 4 below; -- select the Dolby NR system (see page 6) -- adjust the pitch (see page 6) -- activate the Blank Skip function (see page 9) Set the timer to the time you want. When the set time arrives, the tape deck turns on and starts playing. After you have finished using the timer, set TIMER on the tape deck to OFF. If cassettes have been inserted into both decks for single-deck playback, playback will take place only on deck A. Since there are many different types of cassettes on the market, your tape deck automatically sets the appropriate equalization characteristics and bias current for each tape type (ATS: Automatic Tape Selection). In that case, turn the television set off or move it away from the tape deck. Recording on the reverse side on deck B starts simultaneously with playback of the reverse side on deck A. You can add fade-in/out during dubbing Dubbing only specific tracks (Auto Pause) 1 Press AUTO PAUSE before or during normal-speed At the end of each track, both deck A and deck B pauses. Locate the track you want to record next on deck A (see page 9), then stop the tape. Press AUTO PAUSE again to turn off "AUTO PAUSE" in the display. Do not turn on the Pitch Control function (see page 6) or Blank Skip Function (see page 9) while using the Auto Pause function. If you do, the Auto Pause function may not work properly. You can do this only during normal-speed dubbing. Locate the point you want to resume recording on deck A, then stop the tape. You can make a continuous recording that starts on a cassette in deck A and ends on a cassette in deck B. Make sure that record-protect tabs on the cassettes have not been removed. [. . . ] See Pitch control function recording level 4 ATS 12, 22 Auto pause 13 Auto play 9 Automatic calibration 12, 22 Automatic tape selection. This adjustment works together with the deck's ATS (Automatic Tape Selection, see above) to get the best possible recording results on any tape. A function that quickly reverses the tape direction as soon as the tape deck detects the leader tape. This allows recording or playback to continue without a break even when the tape reaches the end. [. . . ]