User manual SONY TC-K707ES

[. . . ] Please note the following distinguishing features of each model: Is for sale in Europe only This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Has an HX PRO button for turning the Dolby HX PRO function on and off · The following icons are used in this manual: Indicates useful information or tips that make a task easier. The model and serial numbers are located on the rear of the unit. Record the serial number in the space provided below. [. . . ] Since there are many different types of cassettes on the market, the tape deck automatically sets the appropriate equalization characteristics and bias current for each tape type (ATS: Automatic Tape Selection). However, you can get better recording results by adjusting the bias current, recording level and recording equalizer. Make sure either 9 or ( does not appear. Adjust REC EQUALIZER CALIBRATION so that both meters reach the recommended level. Turn REC EQUALIZER CALIBRATION clockwise to increase both meters. Turn REC EQUALIZER CALIBRATION counterclockwise to decrease both meters. Insert the cassette you want to record on. ) After two or three seconds, the meters showing the level of the test tones appear in the display. Then adjust, in sequence, the bias, recording level and recording equalizer. adjust BIAS CALIBRATION so that both meters indicate equal signal levels. If the upper meter shows a higher level than the lower meter, turn the BIAS CALIBRATION clockwise. The CD player changes to play pause and the tape deck to recording pause. The tape deck starts recording, and then the CD player starts playing. Press both buttons again to resume Synchro-Recording. You can use the remote of your tape deck to operate the CD player To start CD play, press P twice; to pause CD play, press P once; to locate a CD track, press = or +. Do not disassemble the cabinet -- this may result in an electrical shock. Should any solid object or liquid fall into the cabinet, unplug the tape deck and have it checked by qualified personnel before operating it any further. Before operating the tape deck, check that the operating voltage of the tape deck is identical with your local power supply. The tape deck is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the tape deck itself has been turned off. ⷠIf you are not going to use the tape deck for a long time, be sure to disconnect the tape deck from the wall outlet. To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. ⷠShould the AC power cord (mains lead) need to be changed, have it done at a qualified service shop only. [. . . ] / Reinsert the AC power cord, then close the Passage of low frequencies or very low volume, or a gradual increase or decreace in volume. The space before a track is less than 4 seconds long. Insert a blank space of 4 seconds using R REC MUTE button. The signal strength of the left and right channels are very different. [. . . ]