User manual SONY TCM-200DV

[. . . ] ⷠConnect the AC power adaptor to an easily accessible AC outlet. Should you notice an abnormality in the AC power adaptor, disconnect it from the AC outlet immediately. Please register this product on line at www. Com/productregistration> Proper registration will enable us to send you periodic mailings about new products, services, and other important announcements. [. . . ] When you use the system in a noisy place, the unit will stay in Recording mode. If the sound is too soft, on the contrary, the unit will not start recording. Set it to H (high) or L (low) so that the system will pick up the necessary sound only. If you cannot get the results you want, set it to OFF. ⷠThe VOR system may not record the beginning of the sound you want to record because it starts recording only after it catches the sound. We do not recommend the use of tapes longer than 90 minutes except for a long continuous recording or playback. they are very thin and tend to be stretched easily. This may cause malfunction of the unit or sound deterioration. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. The sound drops out or has with excessive noise. Use the unit away from radiowave-emitting devices such as cellular phones. You are using a High-position (TYPE II) or metal (TYPE IV) tape. Tape speed is too fast or too slow in Playback mode. Set it to the same speed as that used for recording. (TCM-200DV only) · SPEED CONTROL is set at a point other than the center (TCM200DV only). In the direction of the arrow To release pause playback, release PAUSE . Search forward Press and hold during M FF/CUE and playback (CUE) release it at the point you want. Search backward during playback (REVIEW) Fast forward** Rewind** Press and hold m REW/REVIEW and release it at the point you want. [. . . ] Center position to play back at normal speed. FAST (fast) to play back at a faster speed. Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. ⷠShould any solid object or liquid fall into the unit, remove the batteries or disconnect the AC power adaptor, and have the unit checked by qualified personnel before operating it any further. [. . . ]