User manual SONY TCM-22DV

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] ⷠWhen the tape starts running or at the end of the tape the i lamp may momentarily light with a short beep. If the lamp goes off, you do not need to replace the batteries. Connect the AC power adaptor to DC IN 3V and to the wall outlet. Use the AC-E30HG AC power adaptor (not supplied). Check your local voltage and the shape of plug before purchasing. Insert a cassette with the side to start playing facing the lid. To play the tape from the beginning, follow the procedure below. 2 Take out the cassette and reinsert the cassette with side B facing the lid. 4 Take out the cassette and reinsert the cassette with side A facing the lid. 6 Take out the cassette and reinsert the cassette with side B facing the lid. When the tape comes to an end Playback stops and the unit turns off automatically (Automatic shut-off mechanism). When the tape comes to an end Recording stops and the unit turns off automatically (Automatic shut-off mechanism). To Stop recording Pause recording Press or slide p STOP PAUSE c To release pause recording, release PAUSE c*. * PAUSE c will be also automatically released when p STOP is pressed (stop-pause-release function) Note Do not use a CrO2 (TYPE II) or metal (TYPE IV) tape, otherwise the sound may be distorted when you play back the tape, or the previous recording may not be erased completely. To reuse the tape for recording, cover the tab hole with adhesive tape. It is useful to search the beginning of the recording. The sound of monitoring can be adjusted by VOL but the recording level is fixed. Press r REC during playback, recording starts immediately. It is useful when you want to rerecord the portion which was just recorded. While recording, you can record a special signal on the tape to mark a specific position. If you want to record a signal longer than that, press CUE MARKER as long as you want. During cue and review, you will hear the beep sound at the marked position. [. . . ] We do not recommend the use of tapes longer than 90 minutes except for a long continuous recording or playback. they are very thin and tend to be stretched easily. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Erase head Record/playback head Cotton swab To clean the tape heads and path depress r REC while pushing the lever. [. . . ]