User manual SONY TCM-25DV

[. . . ] Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. At the end of the tape, recording stops and the unit turns off automatically. to Stop recording Pause recording Press or slide x STOP PAUSE . In the direction of the arrow To release pause recording, release PAUSE . [. . . ] â· Do not use different types of batteries. â· When you do not use the unit for a long time, remove the batteries to avoid any damage caused by battery leakage and subsequent corrosion. â· Dry batteries will not be drained when another power source is connected. You can record right away with the built-in microphone. Make sure that nothing is connected to the MIC jack (TCM-25DV only). If you do so, the sound may be distorted when you play back the tape, or the previous recording may not be erased completely. Recording will be made independent of this control. 4cm/s): for double recording time (for example, 120 minutes using both sides of a 60-minute cassette). Replace the batteries with new ones when the BATT lamp dims. After the batteries have been used for a while, the BATT lamp may flicker with the playback sound when you turn up the volume; however this does not mean that you need to replace the batteries. â· The unit will play back normally for a while, even after the BATT lamp dims. note When recording with an external microphone, the VOR system may not work properly due to difference in sensitivity . This warranty is valid only in the United States. To clean the tape heads and path press z REC while pushing the lever in the tape compartment. Wipe the heads, pinch roller, and the capstan with a cotton swab moistened with alcohol after every 10 hours of use. Connect another equipment to the MIC jack using the RK-G64HG connecting cord (not supplied). ** If you leave the unit after the tape has been wound or rewound, the batteries will be consumed rapidly. Use a soft cloth slightly moistened in water. Should any problem persist after you have made these checks, consult your nearest Sony dealer. The AC power adaptor is not firmly connected. â· The unit will not run on dry batteries if the AC power adaptor is left plugged into the DC IN 3V jack even though you disconnect the AC power adaptor from the power source (this does not apply to TCM-150 for USA/Canada/ Europe). VOR has been set to the improper position when VOR function works (TCM-25DV only). [. . . ] To start playback again, press x STOP, then press N PLAY. Insert a cassette with the side to be played facing the cassette holder. For AC operation, use the AC power adaptor recommended for the unit. Turn SPEED CONTROL to: SLOW (slow) to play back at a slower speed. [. . . ]