User manual SONY TCM-400DV

[. . . ] Refer to these numbers whenever you call upon your Sony dealer regarding this product. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Make sure that nothing is connected to the DC IN 3V jack. [. . . ] 4cm/s): for double recording time (for example, 120 minutes using both sides of a 60-minute cassette). When you use the VOR system in a noisy place, the unit will stay in Recording mode. If the sound is too soft, on the contrary, the unit will not start recording. Set VOR to H (high) or L (low), depending on the conditions to pick up the necessary sound only. If you cannot get the desired results even after adjusting VOR to H or L, set VOR to OFF. We do not recommend the use of tapes longer than 90 minutes except for a long continuous recording or playback. they are very thin and tend to be stretched easily. This may cause malfunction of the unit or sound deterioration. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. In the direction of the arrow To release pause playback, release PAUSE . Use a microphone of low impedance (less than 3 k) such as the ECM-T6 (not supplied). When using a plug-in-power system microphone, the power to the microphone is supplied from this unit. Search forward Press and hold during M FF/CUE and playback (CUE) release it at the point you want Search backward during playback (REVIEW) Fast forward** Rewind** Start recording during playback Eject a cassette Press and hold m REW/REVIEW and release it at the point you want M FF/CUE during stop m REW/REVIEW during stop z REC The sound drops out or has with excessive noise. Use the unit away from radiowave-emitting devices such as cellular phones. You are using a High-position (TYPE II) or metal (TYPE IV) tape. Tape speed is too fast or too slow in Playback mode. [. . . ] FAST (fast) to play back at a faster speed. Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. â· Should any solid object or liquid fall into the unit, remove the batteries or disconnect the AC power adaptor, and have the unit checked by qualified personnel before operating it any further. [. . . ]