User manual SONY TCM-455V annexe 1

[. . . ] Record the model and serial numbers in the spaces provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. ________________ Serial No. __________________ To monitor the sound For TCM-473V: Connect stereo headphones (supplied) firmly to the 2 (headphones) jack. [. . . ] ·Do not use a new battery with an old one. ·Do not use different types of batteries. ·When you do not use the unit for a long time, remove the batteries to avoid any damage caused by battery leakage and subsequent corrosion. ·Dry batteries will not be expended when another power source is connected. automatically to the sound. H (high) to record at meetings or in a quiet and/ or spacious place. L (low) to record for dictation or in a noisy place. OFF to start and stop recording manually. Note When the sound to be recorded is not loud enough, set the VOR switch to OFF, or the unit may not start recording. Side A Tab for side A When to replace the batteries Replace the batteries with new ones or charge the batteries (TCM454VK only) when the BATT lamp dims. BATT lamp 3 Press r REC. Recording starts. At the end of the tape, recording stops and the unit turns off automatically. To take out the batteries Notes · After the batteries have been used for a while, the BATT lamp may flicker with the playback sound when you turn up the volume; however, this does not mean that you need to replace the batteries. Continue to the reverse side m A 1 Open the battery compartment lid. 2 Insert two size R6 (AA) batteries (TCM-455V for 2 Set VOR to: H or L to start and pause recording Recording from Various Sound Sources The sound is recorded in monaural. MIC (PLUG IN POWER) Playing a Tape VOL z Additional Information Troubleshooting Should any problem persist after you have made these checks, consult your nearest Sony dealer. m The batteries have been inserted with incorrect polarity. m PAUSE c is slid in the direction of the arrow. m The AC power adaptor or car battery cord is not firmly connected. m The batteries have been inserted, but simultaneously the AC power adaptor is connected and not to be done to the wall outlet. m The earphone or headphones is plugged in. Tape speed is too fast or too slow in the playback mode. m SPEED CONTROL is set at a point other than the center. [. . . ] At the end of the tape, playback stops and the unit turns off automatically. To Stop playback/stop fast forward or rewind Pause playback Press or slide p STOP PAUSE c in the direction of the arrow To release pause playdack, release PAUSE c*. Press and hold ) FF/CUE and release it at the point you want Press and hold 0 REW/REVIEW and release it at the point you want ) FF/CUE during stop 0 REW/REVIEW during stop r REC Output TCM-473V: 2 (headphones) jack (stereo minijack) for 8-300 ohms headphones TCM-455V/454VK/453V: Earphone jack (minijack) for 8 - 300 ohms earphone Variable range of the tape speed from +30% to ­15% Power requirements · Two size R6 (AA) batteries (TCM-455V for U. S. A. : supplied. Other models: not supplied): 3V DC · Two NC-AA rechargeable batteries (1. 2 V) (supplied to TCM-454VK) DC IN 3 V jack accepts: · Sony AC power adaptor (supplied to TCM-454VK) or AC-E30HG AC power adaptor (not supplied) suitable in the country where the unit is to be used. [. . . ]