User manual SONY TCM-50DV annexe 1

[. . . ] ) Do not use any other AC power adaptor. 4cm/s): for double recording time (for example, 120 minutes using both sides of a 60-minute cassette). suitable for recording conferences , dictations , etc. When the sound to be recorded is not loud enough, set the VOR switch to OFF, or the unit may not start recording. [. . . ] After the batteries have been used for a while, the BATT/REC lamps may flicker during playback if the volume is turned up. This is, however, not an indication for the batteries to be replaced. The unit will play back normally for a while even after the i lamp flashes. You should, nonetheless, replace the batteries as soon as possible. Otherwise, the built-in speaker may emit a loud noise and recordings may not be made correctly. The i lamp may flash momentarily at beginning of playback or the end of the tape. If the flashing stops right away, you do not need to replace the batteries. The number in the tape counter will increase when playing back the forward side, and decrease when playing back the reverse side. At the end of the reverse side, recording stops and the unit turns off automatically. To Stop recording Pause recording Press or slide p STOP PAUSE c in the direction of the arrow To release pause recording, release PAUSE c*. To record on both sides Slide DIR c so that the FWD indicator turns green. Recording will start from the side facing the cassette holder window (forward side) and switches automatically to the reverse side at the end of the side (Auto Reverse). Set VOR and MIC SENS to suit the recording condition before recording. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. You are using a Hi-position (TYPE II) or metal (TYPE IV) tape. There is a clicking noise during tape operation. PAUSE c in the direction of the arrow To release pause playback, release PAUSE c*. Use a microphone of low impedance (less than 3 kilohms) such as ECM-T110 (not supplied). [. . . ] FAST (fast) to play back at a faster speed. Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. Should any solid object or liquid fall into the unit, remove the batteries or disconnect the AC power adaptor, and have the unit checked by qualified personnel before operating it any further. Keep personal credit cards using magnetic coding or spring-wound watches etc. [. . . ]