User manual SONY TC-M313

[. . . ] To record on both sides Set " DIR " to FWD. Recording will start from the side facing the cassette holder window (forward side) and switches automatically to the reverse side at the end of the side (Auto Reverse). To record on a single side Set " DIR " to REV. Recording will start from the side facing the unit (reverse side). To monitor sound Connect supplied headphones firmly to the 2 jack on the remote control. [. . . ] Note The number in the tape counter will increase when playing back the forward side, and decrease when playing back the reverse side. At the end of the reverse side, recording stops and the unit turns off automatically. To Stop recording Pause recording Press p STOP P PAUSE To release pause recording, press P PAUSE again. * Press and hold REW/REVIEW during recording. Release the button at the point to start. Press p STOP and open the cassette compartment lid by hand. VOR (, ) · VOR , . MIC SENS, VOR OFF. 6 2 REPEAT HOLD SPEAKER IC REPEAT CUE IC REPEAT REVIEW VOL P A a Side A A A 2 c Insert a normal (TYPE I) tape. To record on both sides Place the tape with the side to start recording facing the cassette compartment lid. To record on a single side Place the tape with the side to be recorded facing the unit. Review the portion just recorded z (. , , , , . Take out a cassette 7 Tab for side A A * P PAUSE will also be automatically released when p STOP is pressed (stop-pause-release function). (turn over) r REC. ) English C MIC (PLUG IN POWER) Recording from Various Sound Sources (see Fig. C) Set VOR and MIC SENS to suit the recording condition before recording. To Stop playback/ stop fast forward or rewind Pause playback Press or slide p STOP 3 At the end of the section you want to repeat, press REPEAT. The designated section will be played repeatedly. Press REPEAT To listen with the supplied headphones Securely insert the supplied headphones into the remote control's 2 jack and set VOL on the unit to about 7. Adjust the volume using VOL of the remote control. Tape speed is too fast or too slow in the playback mode. · Improper setting of the REC TIME switch. Set it to the same speed as that used for recording. · DPC is set to AUTO or MANUAL, and SPEED CONTROL is set at a point other than the center. Speed does not change when SPEED CONTROL is turned. Pitch does not change when PITCH CONTROL + or ­ is pressed. · DPC is either on OFF or on AUTO. The tonal quality reproduced by REPEAT is inferior. · If the time from the start of standard playback to the pressing of REPEAT is shorter than designated repeat time, only the portion played will repeat. · The paused sections during standard playback will be repeat-played as blanks and the cued/reviewed sections will be repeat-played as fast-played sound. 2 3 "" PLAY . F) , , , 10 . z Additional Information Precautions On power · Operate the unit only on 3V DC. [. . . ] 200 (1) R6 ( AA) (2) ( Sony) (1) . CUE/REVIEW / (CUE/ REVIEW), . , p STOP, "" PLAY . · CUE/REVIEW, , FF/CUE REW/REVIEW. · , FF/CUE REW/REVIEW CUE/REVIEW, i . Notes on DPC (Digital Pitch Control) · If you set DPC to MANUAL in step 3, adjust pitch using PITCH CONTROL. [. . . ]