User manual SONY TC-M465V

[. . . ] Press 0 while holding down · For the reverse side, press ) while holding down ª. With the side you want to play facing you To play a tape recorded with the Dolby NR* system The Dolby NR (noise reduction) system eliminates tape hiss noise by boosting low-level signals in the highfrequency range during recording, then lowering them during playback. Type C provides greater noise reduction than type B. * The deck automatically stops after playing back five times. [. . . ] ) or 0 when the deck is stopped § after stopping playing Stop playing Start playback from the reverse side Pause (deck B only) Fast-forward or rewind Take out the cassette * Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. Use deck B (on your right hand side) for recording. ⷠSee "Dubbing a Tape" (page 9) to make a copy of the tape. Turn on the amplifier and play the program source you want to record. Press POWER, and then press § and insert a cassette into deck B. With the side you want to record facing you When deck B is recording or in recording pause, all buttons on deck A do not work. After the AUTO indicator lights up continuously, stop playing the program source. If you wish to adjust the recording level manually, see "To adjust the recording level manually" on page 7. To protect recordings against accidental erasure Stop recording Start recording from the reverse side Pause Take out the cassette Distortion and noise in the high-frequency response are reduced to produce highquality sound that can be enjoyed even during playback on other tape decks. After pressing REC r in Step 4 on page 6, turn L R REC LEVEL so that the peak level meters reach the recommended level for the corresponding For type I or tape type. After completing the adjustment, stop type II tape playing the program source, then continue the For type IV tape procedure from Step 5. You can copy a tape in deck A to a tape in deck B at normal or high speed. Insert the recorded cassette into deck A and a blank cassette into deck B. Make sure the record-protect tabs on the cassette in deck B have not been removed. Recording on the reverse side on deck B starts simultaneously with playback of the reverse side on deck A. During fade-in, the AUTO indicator flashes, then goes off when the fade-in has completed. Press FADER when you want to start fading out while recording. Fade-in or fade-out is not possible when REC LEVEL is set to 0 (minimum). Normal speed High speed You don`t have to adjust the recording level or select the Dolby NR system during dubbing Dubbing is automatically performed with the same recording level and Dolby NR system as the original in deck A. If, however, you want to monitor the sound during normal-speed dubbing, set DOLBY NR to match the tape in deck A (see page 5). You can insert a blank space of 4 seconds between each track or erase unwanted portions on a tape. If a TV set is placed near the tape deck, noise may occur during high-speed dubbing. [. . . ] You can insert a blank space of 4 seconds between each track or erase unwanted portions on a tape. If a TV set is placed near the tape deck, noise may occur during high-speed dubbing. In that case, turn the television set off or move it away from the tape deck. You can do this only during the normal-speed dubbing. [. . . ]