User manual SONY TC-M80V

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Then start from Step 2 of the automatic calibration procedure. The Auto Rec Level function automatically measures the peak signal level and adjusts the recording level accordingly. The Auto Rec Level function operates during normal recording, Relay Recording or Simultaneous Recording on either deck. You should adjust the recording level manually with the REC LEVEL control in the following cases: â· The recording level cannot be adjusted properly due to excessive noise in the program source. â· The program source level is too low and the recording level does not increase. During a quiet passage in a program source such as classical music, the recording level may not increase for some time. If a high sound level is expected later on in the track, play that portion first so that the right adjustment can be obtained. â· The recording level does not decrease for a long time. The Auto Rec Level function may not work properly when you try to record sound produced by a graphic equalizer that has extremely high-level signals. To record with the optimum recording level â· To prevent changes in the recording level after recording starts, press REC r while playing the highest sound level portion of the program source to be recorded. If you play the entire program source after the AUTO indicator has stopped flashing and is lit continuously, the deck will set the recording level for the portion of the program source with the highest signal level. Adjust the recording level manually, if necessary (see page 7). The Control A1 cord supports advanced functions not possible with the commander-based CD synchro-recording function on previous models. Further information on the various operations made possible by a Control A1 cord is provided in the pamphlet attached to this manual. After 4 seconds, P lights up and the tape deck changes to recording pause. If you want to insert a blank space longer than 4 seconds Hold down REC MUTING R as long as you want. After 4 seconds, "REC" flashes faster. When you release REC MUTING R, P lights up and the tape deck changes to recording pause. Select the side you want to start recording from on deck B. If your CD player has the Peak Search function The SYNCHRO button indicator lights up and the CD player locates the highest signal level among the tracks to be recorded as the tape deck adjusts the recording level. When the recording level adjustment is completed, CD Synchro-recording starts. If your CD player does not have the Peak Search function The CD player changes to play pause and deck B to recording pause. [. . . ] Move the tape deck away from the TV or VCR. / The tape deck is placed on or under the amplifier. Move the tape deck away from the amplifier. / A power failure has occurred, the tape deck has been turned off or the power cord has been disconnected during tape operation. [. . . ]