User manual SONY TC-M81

[. . . ] The AU BUS connecting cable is used for exchanging signals between the tape deck and the DHC-MD313/ 333. If you do not connect the cable firmly, the tape deck and DHC-MD313/333 may not operate correctly. The two audio connecting cords are the same, so you can connect A or B using either cord. VOLTAGE SELECTOR to the position of your local power line voltage. [. . . ] â· To start playing automatically from the beginning of the tape after fast winding (Auto Play), press H while holding down m (for the top side) or press h while holding down M (for the bottom side). â· To listen to a tape recorded with the Dolby noise reduction system, set DOLBY NR to ON. â· Using the timer function on the stereo system, you can wake up to music at a preset time. for details , refer to "Wake up to music" in the stereo system operating instructions. When you set the Wake-up timer, DOLBY NR must be set on the tape deck. * You cannot use the remote supplied with DHCMD595. ** The Automatic Music Sensor (AMS) feature detects a blank space of more than four seconds between tracks to locate tracks quickly. The AMS feature may not work in the following cases: -- the blank space between tracks is four seconds or less. -- the sound source recorded on the right channel is different from that on the left channel as with a KARAOKE tape. -- low volume or low sound continues for a long time. The CD SYNC button lets you record from a CD to a tape easily. â· Unplug the tape deck from the wall outlet (mains) if it is not to be used for an extended period of time. To disconnect the cord (mains lead), pull it out by the plug. Should any solid object or liquid fall into the component, unplug the tape deck and have it checked by qualified personnel before operating it any further. â· The AC power cord (mains lead) must be changed only at a qualified service shop. Place the tape deck in a location with adequate ventilation to prevent heat build-up in the tape deck. â· Do not place the unit in an inclined position. â· Do not place the unit in locations where it is: -- Extremely hot or cold -- Dusty or dirty -- Very humid -- Subject to vibration -- Subject to direct sunlight The cassette indicator lights up in red when a cassette is inserted and goes off when no cassette is inserted. â· When you want to reduce the hiss noise in low-level high-frequency signals, set DOLBY NR to ON before step 5. â· Using the timer function on the stereo system, you can record radio programmes at a preset time. for details , refer to "Timer recording radio programmes" in the stereo system operating instructions. When you set the timer recording, DOLBY NR and DIRECTION mode must be set on the tape deck. [. . . ] There is excessive wow or flutter, or the sound drops out. Noise increases or the high frequencies are erased. Move the tape deck away from the TV or VCR. Move the tape deck away from the TV or VCR. [. . . ]