User manual SONY TC-RX410

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] To locate the memorized point and start playback, press 0 (or )) while holding down · The Auto Rec Level function automatically measures the peak signal level and adjusts the recording level accordingly. You should adjust the recording level manually with the REC LEVEL control in the following cases: ⷠThe recording level cannot be adjusted properly due to excessive noise in the program source. ⷠThe program source level is too low and the recording level does not increase. During a quiet passage in a program source such as classical music, the recording level may not increase for some time. If a high sound level is expected later on in the track, play that portion first so that the right adjustment can be obtained. ⷠThe recording level does not decrease for a long time. The Auto Rec Level function may not work properly when you try to record sound produced by a graphic equalizer that has extremely high-level signals. To record with the optimum recording level ⷠTo prevent changes in the recording level after recording starts, press REC r while playing the highest sound level portion of the program source to be recorded. If you play the entire program source after the AUTO indicator has stopped flashing and is lit continuously, the deck will set the recording level for the portion of the program source with the highest signal level. Make sure that record-protect tabs on the cassette have not been removed. The AUTO indicator lights up continuously after the recording level has been adjusted. If, however, you want to monitor the sound during normal-speed dubbing, set the DOLBY NR selector to match the tape in deck A (see page 5). After 4 seconds, P lights up and the tape deck changes to recording pause. If you want to insert a blank space longer than 4 seconds Hold down REC MUTING R as long as you want. After 4 seconds, "REC" flashes faster. When you release REC MUTING R, P lights up and the tape deck changes to recording pause. If a TV set is placed near the tape deck, noise may occur during high-speed dubbing. In that case, turn the television set off or move it away from the tape deck. You can do this only during the normal-speed dubbing. Locate the point you want to resume recording on deck A, then stop the tape. By pressing the SYNCHRO button, you can perform synchro-recording on your tape deck with a Sony CD player connected to the CONTROL A1 connector through a Control A1 cord (see page 4). The Control A1 cord supports advanced functions not possible with the commander-based CD synchro-recording function on previous models. [. . . ] / One of the tracks contains a long pause, a passage of low frequencies or very low volume, or a gradual increase or decreace in volume. / The space before a track is less than 4 seconds long. Insert a blank space of 4 seconds using the REC MUTING R button. / The signal strength of the left and right channels are very different. [. . . ]