User manual SONY TDM-MP 10

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] Make sure the AV system is turned off before connecting. Turn on the AV system with a DIGITAL MEDIA PORT jack connected to this unit, and select the DIGITAL MEDIA PORT function. To remove the DIGITAL MEDIA PORT cable from the DMPORT jack, press both side buttons. Before disconnecting, turn off the AV system. To adjust the unit's connector position This unit can be rotated 90 degrees to the left or right according to the position of the connector on the mobile phone. For a mobile phone with the connector on the bottom To put the mobile phone into the unit's connector Put the mobile phone into the unit's connector. Depending on the type of mobile phone, there may be a gap between the back of the mobile phone and the unit. If this gap is large and the mobile phone is unstable, use the supplied padding stickers to fill the gap. For a mobile phone with the connector on the left side Doing so may damage the unit. When placing or removing the mobile phone, do not twist or sway the mobile phone, keeping it aligned with the unit, to prevent connector damage. Do not carry the unit with a mobile phone set on the connector. When placing or removing the mobile phone, brace the unit with one hand and take care not to press the controls of the mobile phone by mistake. When placing the mobile phone, pause playback. To use the unit as a battery charger You can use the unit as a battery charger. While the power indicator lights up, the battery is charging. You can operate your mobile phone by its control buttons, the control buttons of a connected AV system with a DIGITAL MEDIA PORT interface (Sony DAV series, etc. To use a mobile phone, refer to the user's guide of your mobile phone. Before disconnecting the mobile phone, pause playback. [. . . ] Use caution when placing the unit on surfaces that have been specially treated (with wax, oil, polish, etc. Although the unit heats up during operation, this is not a malfunction. Place the unit in a location with adequate ventilation to prevent heat buildup in the unit. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. [. . . ]