User manual SONY TDM-NC1 Installation Guide

[. . . ] This unit cannot connect with a computer directly using a wireless ad-hoc network. 1 2 Turn on your computer and login as an administrator. Wait for Windows to load. 3 4 If the "Windows Security Alert" window appears Select the language to be used. Click [M-crew Server setup]. The installation starts. [. . . ] For Windows Vista users The "Auto Play" window appears, click [Run setup. exe] to install the program. Then, the "User Account Control" (UAC) window appears, click [Allow]. If you click [Cancel], you will not be able to start the installation. 1 Click to place a check next to the directory path that contains the files to be loaded. Click again to remove checks next to paths that are not to be loaded. Tip Sub-folders of the selected folder are also subject to the AUTO LINK function. 1 2 Click [Enable]. "Enable" or "Disable" appears for each item. If "Disable" appears, click [Enable] repeatedly until "Enable" appears for all status items. TDM-NC1 Operating Instructions/M-crew Server Ver. 2. 5 software CD-ROM Click [Close]. The "Security software Firewall setting guide" window appears automatically. Go to STEP . Continued STEP Make the Security Software Firewall Settings If commercially available anti-virus software is installed on your computer, this setting opens the Firewall. If the security software is not installed on your computer, click [Close] then go to STEP . 2 Install the TDM-NC1. Connect the DIGITAL MEDIA PORT cable of this unit to an AV system (DAV series, etc. ). AV system with DIGITAL MEDIA PORT interface (back panel) Case B: Make the wireless connection 1 Turn on the AV system connected to the unit, and 2 switch the AV system function to DMPORT. Confirm the settings of your wireless system. Check the following items of your wireless LAN router to set the same information for the TDM-NC1. SSID (Wireless Network Name): If your wireless LAN router security is enabled, Wireless Network Key: Tips For details on how to check the wireless LAN router settings, refer to the operation manual of your wireless LAN router. In some case, SSID name and wireless network key numbers/characters are written on the wireless LAN router. Check that your wireless LAN router uses the latest firmware version. For details, refer to the operation manual of your wireless LAN router. STEP Check the Operations 1 Make sure the display message of the unit. The message "Configuring" appears, then "Loading" follows and then disappears. If "SERVER?" appears, go to step 2. Notes If "Check Net" appears, check the network settings in STEP . Or, the wireless signal may be weak or out of range, move the unit closer to the wireless access point. [. . . ] Letter types changes as shown below: upper case lower case number symbol space 3 Go to STEP to check the operations. 8 Press ENTER. The unit restarts, go to STEP . Note If you set wireless network key (WEP key) to other than "WEP key No. 1", you need to select the Case C connection. [. . . ]