User manual SONY TMR-BT8IP-W

[. . . ] and any use of such marks by Sony Corporation is under license. Other trademarks and trade names are those of their respective owners. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ] If you turn off this unit while the iPod is playing back, iPod will power off. It is not recommended to turn off iPod as the linkage will lost between this unit and the Bluetooth receiving device. There is no need to charge this unit as it will receive power from the connected iPod. Bluetooth devices need to be "paired" with each other beforehand. Once Bluetooth devices are paired, there is no need for pairing again, except in the following cases: Pairing information is deleted after repair, etc. This unit is paired with 9 or more receiving devices. This unit can be paired with up to 8 Bluetooth receiving device. If a new device is paired after 8 devices have been paired, the device whose latest connection time is the oldest among the 8 paired devices is replaced by the new one. Place this unit and the Bluetooth receiving device to be paired together within 1 m (3 ft). Press and hold the POWER button of the bluetooth receiving device for 7 seconds or more to standby for pairing while the unit is turned off. Passcode* of this unit is fixed at "0000", "1234" or "8888. Before starting operation, complete pairing this unit and the Bluetooth receiving device (page 10). Connect this unit to the iPod then turn on the iPod and start playback on the iPod. This unit's indicator status will vary as follows, and the Bluetooth connection between this unit and the Bluetooth receiving device is established. Indicator flashes twice: Power is on Indicator flashes (at about 1-second intervals): Connecting in process Indicator flashes twice slowly (at about 5-second intervals): Connected (Playback will start automatically) If the Bluetooth connection is not established within 5 minutes*, this unit automatically turns itself off. In this case, turn it on again by pressing and holding the power button for about 1 second. * iPod backlight may turn on in this 5 minutes. If the Bluetooth connection cannot be established with the device paired already, try pairing again. If playback cannot start automatically, try start playback on iPod. If you press and hold the power button on this unit for about 1 second, this unit will connect to the iPod and start playback automatically. Even if you control the volume on the iPod, sound from the Bluetooth receiving device will not change. If this unit and the Bluetooth receiving device become out of range and the Bluetooth connection terminates, repeat the procedure from step 1. [. . . ] ­ Install this unit and Bluetooth device as near to each other as possible. ­ If this unit is used within about 10 meters (about 30 feet) of a wireless LAN device, turn off the wireless LAN device. Microwaves emitting from a Bluetooth device may affect the operation of electronic medical devices. Turn off this unit and other Bluetooth devices in the following locations, as it may cause an accident. [. . . ]