User manual SONY TMR-RF960R

[. . . ] Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. If the plug supplied is not suitable for the socket outlets in your home, it should be cut off and an appropriate plug fitted in accordance with the following instructions: The wires in this mains lead are coloured in accordance with the following code: Blue Neutral Brown Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. [. . . ] to do this: After selecting the option , press . Then press Reduce and finally press OK to store. If you turn off the TV whilst the Power Saving mode is on, the mode stays on next time you turn on the TV. If you select the "Movie, " "Personal1" or "Personal2" mode on the "Picture Adjustment" menu (page 13), you can adjust the picture option even if the Power Saving mode is set to on. Note that power consumption will still increase if you increase the Contrast or Brightness. TV Speakers The "TV Speakers" option allows you to control the sound output of the TV's speakers when using your audio system speakers. Then press or to select After selecting the option, press Off and finally press OK to store. Sound of the TV is not output through the TV's speakers. Orbit Range: Select the moving range from Large, Mid (Middle), and Small. Orbit Cycle: Select the moving time from 10sec, 30sec, 1min, and 5min. The "AV3 Output" option allows you to select the source to be output from the Scart connector 3/ S . A) If you want to use one of the predefined labels (CABLE, GAME, CAM, DVD, VIDEO, or SAT), press or to select the desired label and finally press OK to store. B) If you want to set a different label, select Edit and press . Then with the first element highlighted, press /// to select the letter, then press OK. To correct the letter, select on the screen to go back and press OK. Manual The "Manual Programme Preset" option allows you to: Programme Preset A) Preset Channels or a video input source, one by one, in the programme order of your choice. to do this: 1 After selecting the "Manual Programme Preset" option , press then with Programme option highlighted press . Press or to select on which programme number you want to preset the channel (for VCR, select programme number "0"). 2 The following option is only available depending on the country you have selected in the "Language/Country" menu. After that, press the number buttons to directly enter the channel number of the TV Broadcast or the channel of the VCR signal. If you do not know the channel number, press or to search for it. Next press to select OK and finally press OK to store. [. . . ] Do not use 300-ohm twin lead cables as interference may occur. Check if any connected optional equipment is installed in front of the TV or at the side of the TV. When installing optional equipment, leave some space between the optional equipment and TV. Leave a space of 30 cm between your VCR and the TV to avoid noise. [. . . ]