User manual SONY TSL-S9000L

[. . . ] The model and serial numbers are located on the rear. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Information WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] â· As shipped from the factory, SCSI parity is enabled and Term power is ON. Since the terminating resistor inside the drive is disabled, a SCSI bus terminator must be connected to the SCSI bus before use. â· Before changing the SCSI ID setting, be sure to turn off the power with the POWER switch on the front panel. This section describes users of the LCD (display), and procedures for loading cartridges in the magazine, using the drive unit, and handing magazines and cartridges. Certain machine settings can be made and viewed from the LCD Menu screen, including model and firmware version display and the current SCSI ID setting of the machine. the Menu screen is controlled by the following procedure. Note: The magazine should be removed before switching display to the Menu screen. When the magazine is inserted into the autoloader, the Menu screen can only be displayed when the LCD shows "Ready". To change the language setting, the magazine must be removed. 2 Press the SELECT button to move the cursor (z) among the menu items. Following descriptions of the choices for each setting screen. If no further action takes place for 10 seconds, the menu is exited and display returns to normal. When Version is selected in the Menu screen, the following screen appears, where you can confirm the autoloader model, SCSI ID, firmware version and serial number. Model Name of this Machine SCSI ID Number Firmware Version Loader Serial Number Embedded Drive Serial Number When Auto Load is selected in the Menu screen, the following screen appears. From this screen you can select whether a cartridge automatically loads into the DDS drive when a magazine is placed in the auto loader. 1 Press the SELECT button, if necessary, to move the cursor (z) to the desired setting. When ON is selected and a magazine is placed in the autoloader, the first cartridge automatically loads into the DDS drive after the cartridges have been checked. When OFF is selected, autoloading does not occur. You can press the EJECT button to cancel any change to the selection and return to the Menu screen. 2 Press the ENTER button to accept the selection and return to the Menu When Unload is selected in in the Menu screen, the following screen appears. From this screen you can select what happens when the last cartridge finishes processing: that is, whether it is simply unloaded from the DDS drive, or if the first cartridge is subsequently reloaded and processing continued automatically (in a continuous loop). 1 Press the SELECT button, if necessary, to move the cursor (z) to the desired setting. [. . . ] Do not use alcohol, paint thinner, bug sprays or other volatile solvents, as they can damage the finish. Make sure that the place of installation has a level surface; otherwise, the magazine may fall out when it is ejected. The shutter on the face of the cartridge is opened automatically when it is inserted into the drive. Do not open the shutter by hand, as touching the tape may damage it. [. . . ]