User manual SONY TSLSA300C

[. . . ] How to Use this Guide This Guide describes the AIT Autoloader Unit TSLSA300C/A310C, and how to take care of it. Please read it carefully before using the unit, and keep it handy for future reference. the Guide consists of two parts , plus the specifications. Refer to the parts that relate to your use of the unit. [. . . ] Following descriptions of the choices for each setting screen. If no further action takes place for 10 seconds, the menu is exited and display returns to normal. When Version is selected in the Menu screen, the following screen appears, where you can confirm the autoloader model, SCSI ID and firmware version. Model Name of this Machine SCSI ID Number Firmware Version Auto Loader Serial Number AIT Drive Serial Number When Auto Load is selected in the Menu screen, the following screen appears. From this screen you can select whether the first cartridge automatically loads when a magazine is placed in the auto loader. OFF: The cartridges are checked and auto loading does not occur. ) Please use this as the usual mode of operation. ON: The first cartridge automatically loads into the AIT drive after the cartridges in the magazine have been checked. 1 Press the SELECT button, if necessary, to move the cursor (z) to the desired setting. You can press the EJECT button to cancel any change to the selection and return to the Menu screen. 2 Press the ENTER button to accept the selection and return to the Menu When Unload is selected in the Menu screen, the following screen appears. 1 First, load two data cartridges into the bottom shelf of the magazine as shown in the figure below. Load cartridge number 2 first, followed by cartridges 1. Loading data cartridges into the bottom magazine shelf 2 Load two data cartridges into the top shelf of the magazine as shown in the figure below. Load cartridge number 3 first, followed by cartridges 4. 1 Pressing down on the magazine stopper, place your finger in the hole at The rear of the magazine and push data cartridges toward the front of the magazine. 2 Repeat step 1 to remove three cartridges. 3 Turn the magazine so that the open end faces up and tap it gently against Your hand or a soft object. This makes cartridges move from the top shelf to the bottom shelf. Moving top shelf cartridges to the bottom shelf 4 Using the same technique as step 1, slide the cartridge out from the 1 Be sure to push the cartridges all the way into the magazine. if the Cartridges are not pushed in all the way, the hook on the magazine protrudes outward, and will prevent magazine insertion into the Autoloader. When the magazine is loaded, the following actions occur: · As each cartridge is checked, its number blinks. [. . . ] The shutter on the face of the cartridge is opened automatically when it is inserted into the drive. Do not open the shutter by hand, as touching the tape may damage it. ⷠMagazines and cartridges are carefully adjusted during assembly at the factory. Please do not try to open them or take them apart. [. . . ]